News for hackers. Stuff that matters.
Re:Setting up Starlink by oxplot on Saturday April 10, 2021 @10:19AM (#26761647)
Note that one can use any router with the dish. Basically the dish provides you with a NATed private IP which you can assign to the WAN interface of your router of choice and go from there.
Re:Setting up Starlink by wyager on Saturday April 10, 2021 @01:44PM (#26763363)
It’s a bit more complicated than that if you want reliability. They have two IP ranges on the same physical link, and their patched DHCPD is not standards compliant. If the dish loses its connection, you will be stuck with a useless local IP unless you block DHCP leases in the 192.168 range.
Re:Setting up Starlink by tyingq on Saturday April 10, 2021 @10:23AM (#26761673)
Oh, that's interesting. Is the router then completely just a commodity thing that has no specific Starlink functionality at all?

Edit: Some reddit posts suggests the Starlink App doesn't work if you don't use the router. But also that the app isn't terribly useful outside of the "obstructions view", which is mostly a one-time need during installation.

Re:Setting up Starlink by ShockedUnicorn on Saturday April 10, 2021 @11:26AM (#26762139)
The starlink app works with your own router, you just need to set up a static route.

https://www.reddit.com/r/Starlink/comments/jqhoqz/starlink_a...

Re:Setting up Starlink by yokem55 on Saturday April 10, 2021 @11:32AM (#26762192)
It works fine if you add a static interface route to 192.168.100.1/32 on the wan interface of your router.
Re:Setting up Starlink by freedomben on Saturday April 10, 2021 @10:34AM (#26761758)
That's correct. The starlink app only works when using the included router. The app is useful if you like to see numbers and graphs of dropped packets, throughput, etc, but otherwise isn't needed.
Re:Setting up Starlink by geerlingguy on Saturday April 10, 2021 @11:24AM (#26762117)
I haven't tested this yet, but apparently if you use your own router you may be able to get an IPv6 address assigned.