I know it's absurd to worry about the last few ms, but it's part of what interests me about the project. The goal is to make The Wall Time as accurate as I can. I could go further with a delay locked loop fed from measuring nixie tube current. There is room push down to the dozens of nanoseconds of error relative to the PPS source, but I am content with the 10s of microseconds. I can't imagine ever having access to a camera that could capture that amount of error.
Thanks for the tip. Hardware timers are best. I'll likely have to take some measurements to calibrate the computation time of getting the system time and performing the subtraction.
I'm currently trying to source PPS from software with this repo: https://github.com/twteamware/raspberrypi-ptp/blob/master/pp...
You might find this repo interesting.
I have a 500 MHz oscilloscope on hand so I can decently measure the offset between the raspberry pi PPS and GPS PPS.
This works because a thread of execution generally knows what time it is with higher precision than it can accurately schedule itself.
I'm not sure I understand how you're using a PPS signal to drive a display, though. Is it an LED segment display? I assume you want it to update once a second, precisely on the edge of each second. Displays generally exist for humans, though, and a human isn't going to perceive a few milliseconds of jitter on a 1Hz update.