Re:What I Learned From Fixing my Laptop's Motherboard
by swishercutter on Tuesday May 31, 2011 @10:56PM
(#2605747)
If you are replacing the connector and you don't care about reuse I find it is best to cut off the part then just do cleanup, remove as much as you can to eliminate the heatsinking. Then its up to tip size, temperature and flux...even still I can't say I have not lifted a few pads in my day.
Re:What I Learned From Fixing my Laptop's Motherboard
by chopsueyar on Tuesday May 31, 2011 @08:20AM
(#2602251)
Do you use a de-soldering iron?
Replacing through-hole parts on motherboards is exceptionally difficult. There's so much copper in a modern multilayer board that it's very difficult to get enough heat in without cooking something delicate. Even with preheat, a reflow gun and a powerful iron it can be very hard going.
Replacing broken PSU connectors is one of the most common laptop repairs and should be an easy job, but has a dismally low success rate.