News for hackers. Stuff that matters.
Re:How to Turn an IKEA Coffee Table into a DIY Server Rack by high_density on Sunday January 31, 2021 @07:45AM (#25978395)
what about upgrading fans to silent fans? Has anyone tried noctua fans?
Re:How to Turn an IKEA Coffee Table into a DIY Server Rack by nippoo on Sunday January 31, 2021 @07:56AM (#25978450)
This is a typical 1U server fan. https://youtu.be/YrU1D4bgn78

There's not a lot of space left in a 1U server, and to get the right airflow, the airspeed has to be much much higher as what you'd get in a normal ATX case.

Can you replace it with quieter small fans, while maintaining good airflow? Sure sometimes. Is it ever going to be "quiet"? Not a chance.

Re:How to Turn an IKEA Coffee Table into a DIY Server Rack by detaro on Sunday January 31, 2021 @08:14AM (#25978550)
Of course 1U servers are the most extreme case. Having rackmount equipment at home is fine if you can put it out of the way and pay a bit of attention to what you buy - i.e. a 3U or 4U machine will usually have much more normal fans you can swap to quiet ones. Some people also swap fans on 1U switches.
Re:How to Turn an IKEA Coffee Table into a DIY Server Rack by MasterScrat on Sunday January 31, 2021 @08:58AM (#25978840)
Pro-tip: removing the fans from switches make them much quieter!

More seriously: most switches will survive fine without fans if you don't use them too intensely (see eg https://www.reddit.com/r/Cisco/comments/3iu57s/home_lab_swit...)

Re:How to Turn an IKEA Coffee Table into a DIY Server Rack by tumaal on Sunday January 31, 2021 @08:54AM (#25978822)
Contrary to what some sibling comments suggest, I am currently using an older HPE-2530-48G-PoEP switch with the 3 builtin fans swapped for Noctua nf-a4x20-pwm (installation went very smoothly). They are actually less audible than the disks of my NAS next to it. Admittedly, I am only using about third to half the ports and the load is only moderate most of the times but this setup has been working flawlessly for over a year now.

I guess it depends on your workload and the specific hardware involved but using server hardware with quiet fans in a living room environment can certainly be achieved.

Re:How to Turn an IKEA Coffee Table into a DIY Server Rack by numpad0 on Sunday January 31, 2021 @01:51PM (#25981379)
Server fans are like 12V 1A, Noctua don’t make that kind of fans.

Fan diameter actually corresponds to server thickness. 1U use 4cm, 3U and 4U use 8 or 12cm. Power consumption stays the same, which means monsters like 1U Xeons come with like horizontal 8-unit array of a pair of contra-rotating 4cm 12V/0.5A(12V x 0.5A x 2 in series = 12W per unit) fans.

Noctua don’t make that kind of jet engines.

Re:How to Turn an IKEA Coffee Table into a DIY Server Rack by ezconnect on Sunday January 31, 2021 @08:48AM (#25978788)
The fan will be more expensive than the one it is cooling and it wont make much difference in sound and it might even overheat because the silent fan run slower less air flow.
Re:How to Turn an IKEA Coffee Table into a DIY Server Rack by GordonS on Sunday January 31, 2021 @08:21AM (#25978601)
Aren't Noctua fans quite large, like 12cm in diameter? In a 1U chassis, your fan can only be around 4cm in diameter, because they have to be mounted at the back. You can't mount them horizontally, because of course rack units are meant to be stacked close together.
Re:How to Turn an IKEA Coffee Table into a DIY Server Rack by jowsie on Sunday January 31, 2021 @08:44AM (#25978760)
They start small enough for cooling VRM's and go up to iirc 20cm
Re:How to Turn an IKEA Coffee Table into a DIY Server Rack by Macha on Sunday January 31, 2021 @09:44AM (#25979164)
Note that small noctuas are not magic, like other small fans they're noticeably louder than larger fans.
Re:How to Turn an IKEA Coffee Table into a DIY Server Rack by numpad0 on Sunday January 31, 2021 @01:57PM (#25981439)
Servers people are talking here are like 5cm thick and like 125W per CPU
Re:How to Turn an IKEA Coffee Table into a DIY Server Rack by bitcharmer on Sunday January 31, 2021 @09:57AM (#25979272)
Not sure how relevant my case is for the discussion because I have a dual socket Xeon workstation in a tower case. I built my rig with the big noctua coolers with brown fans. They are super quiet and highly recommend them.
Re:How to Turn an IKEA Coffee Table into a DIY Server Rack by IshKebab on Sunday January 31, 2021 @08:18AM (#25978585)
There aren't any silent server fans. They're small high speed ones (they have to be because of the height restriction) so there's no way you can put a large low speed fan in like you can with a desktop. Plus servers run hotter precisely because they can have loud fans with lots of airflow.
Re:How to Turn an IKEA Coffee Table into a DIY Server Rack by pmlnr on Sunday January 31, 2021 @08:27AM (#25978647)
Doesn't work; the 1U fans are a different format, than any noctua I was able to locate. Regardless I tried putting noctua in a 1U rack, ended up with horrible hack like this: https://petermolnar.net/article/home-server-downsizing/inwin...