News for hackers. Stuff that matters.
Re:Print this file, your printer will jam (2008) by ComputerGuru on Saturday December 26, 2020 @11:56AM (#25544609)
As a long-time owner of AWD performance vehicles (Midwest for you, possible snow eight months of the year!) I can assure that whether or not you replace your tires four, two, or even just one at a time, there are absolutely zero visible/immediately tangible repercussions and the issue described with the Tesla is absolutely not normal even under those circumstances.

As for the long term ramifications, you’ll definitely see increased wear/camber on the opposing tire(a) and I’ve read it could theoretically cause issues with the diff, but I find that extremely hard to believe at least for the cats I’ve driven, because the front:back power ratio is dynamically recalculated and changed continuously depending on driving conditions. If it were 4WD rather than AWD, that might be the case though.

Re:Print this file, your printer will jam (2008) by o-__-o on Saturday December 26, 2020 @12:55PM (#25545055)
Okay here is anecdotal experience. I had a set of treads on my rear tire at 15/32 while the fronts where at 9/32. Viscous coupled AWD with traction control via four-wheel braking. I first noticed something was up when the car would launch rather quickly. I added an odb-2 reader and saw my AWD clutch was engaging a lot. Thought this was by design due to my heavy foot. Then the clunking started.

The AWD would rather stay engaged which puts strain on the transmission to shift harder. Over time this showed up as increased transmission temperatures. My transmission is sensitive to heat but has a poor design which makes any heat a very big deal. At about the same time I was researching new wheels and determined I could fit 9” wide tires in the rear vs 8.5” in the front. A staggered wheel set would give me more rear wheel power bias, but the closest I could get in tire size was still almost .5% larger in diameter.

In all my research it turns out you need tires of the same size within 3/16 wear of each other to avoid non-full time AWD transmissions from doing dumb things like my car does. You see, the AWD clutch simply engages a power transfer unit and then depends on ABS to control power sent by the differential to individual wheels. That system needs to recalibrate itself regularly and it does this when the clutch disengages. When it doesn’t, all sorts of warnings are tripped (in my car I went down 6 floors of a spiraling parking garage exit at 15-20mph and at the 2nd floor a “service stabili-trak” icon appeared on my dashboard)

In cars with a well designed AWD system this will not happen.. but most cars are not designed to engage in AWD for prolonged periods of time and are really there as a beefed up version of traction control. For instance my Torsen Quattro AWD Audi had full time AWD and never had this problem nor would a Nissan GT-R. But for that fancy Lexus or Hyundai AWD, you may want to make sure you stick to the recommended tire rotation schedule

To end my story, I was at the service center and they mentioned I should get my transmission checked out by the bigger repair bay because of the clunking. I suggested it may be the wear of the tires and they agreed to see if that solved the problem. New set of tires and the clunking, extra AWD engagement, and transmission temps went away.

Re:Print this file, your printer will jam (2008) by ComputerGuru on Saturday December 26, 2020 @01:04PM (#25545128)
Interesting story. And yes, I was specifically referring to full-time AWD with or without a rear bias, like that in the Audi Quattro (who I personally think does an excellent job).

I actually don’t consider a car that doesn’t have full-time AWD to be AWD at all, isn’t that considered 4WD?

Re:Print this file, your printer will jam (2008) by o-__-o on Saturday December 26, 2020 @01:46PM (#25545424)
I understand AWD to be exactly that, all wheels providing driving traction. We have advanced long from the Audi 200 days to where part-time AWD is as simple as $700 in parts (for my car).

4WD (4x4) is full time (typically selectable but cannot be changed while in motion). 4WD has a greater gear ratio to really put power to the wheels that have grip, so while all 4WD cars can be considered AWD, AWD cannot be considered 4WD. I’m sure some jeep owner can give a better rundown on why 4WD is named the way it is..

Re:Print this file, your printer will jam (2008) by alistairSH on Saturday December 26, 2020 @05:19PM (#25546884)
In the US, 4WD (4x4) means when the system is engaged, the center diff is locked. Sometimes there'll be some combo of front and rear lockers or LSD units, but not always. When engaged, the center diff is locked, so these systems are typically only engaged off-road or in snow.

And AWD is any system that drives all 4 wheels permanently. In fancy systems, the ratio sent to front vs rear might vary from 50/50 to 0/100, but it's always engaged to some extent. These systems are safe for regular on-road use.

Pick-up trucks and truck-based SUVs usually have 4x4 systems (with a few exceptions like the Land Cruiser and Lexus GX which are both AWD).

Cute utes and cross-overs, plus the odd-ball sedans and wagons (Subaru, VW 4Motion, Audi) are usually AWD.

Edit - as noted in a sibling comment, the line has definitely blurred with fancy electronically controlled and viscous couplings, but generally "truck" = 4x4 and cross-over/wagon = AWD.

Re:Print this file, your printer will jam (2008) by ComputerGuru on Saturday December 26, 2020 @03:38PM (#25546284)
I don’t think 4WD/4x4 is a strict subset of AWD or the other way around. One is typically manually selected, the other is typically always on at a certain ratio but (at least in modern variants) dynamically adjusted (or at least theoretically adjustable) either on a front/back or even on a per-wheel basis based on dynamic real-time feedback.

TBH the line has blurred considerably in recent years and what once would have been 4x4 (manually engaged fixed-ratio four wheel mode) is being marketed as AWD. I’m sitting in a rental GMC Terrain (very crappy car, with or without AWD) and it must be manually switched from 2WD to 4WD mode but it’s an electronic button (rather than gear selection lever) that can be changed at speed, and can also be used in 4WD mode at highway speeds without redlining. This is considerably different from body-on-frame SUVs/pickups with “true” 4x4 mode that have regular 2WD but can be changed into 4L or 4H to get different gearing ratios inside the transfer case for four wheel drive.

Re:Print this file, your printer will jam (2008) by macintux on Saturday December 26, 2020 @02:03PM (#25545545)
> typically selectable but cannot be changed while in motion

Not true for a long time now. Manually locking hubs required egress while stopped but at some point 4wd tech progressed.

Re:Print this file, your printer will jam (2008) by frankchn on Sunday December 27, 2020 @03:50AM (#25549789)
Yeah, the most advanced systems can switch between 4WD and RWD while the drivetrain is under considerable stress too. For instance, the F90 M5 can engage the front wheels on command while in the middle of a power slide and let the front wheels pull the car out of the slide.
Re:Print this file, your printer will jam (2008) by o-__-o on Sunday December 27, 2020 @10:05AM (#25551498)
M5 is not 4WD. Just an electronically controlled clutch like my car.
Re:Print this file, your printer will jam (2008) by thatcat on Saturday December 26, 2020 @06:56PM (#25547487)
there are different forms of awd. Some "awd" is mechanical with even 50:50 or a 40:60 distribution of power like the quattro system that have a center differential. These systems still work great with large differences in traction: if you put snow tires on the front and regular tires on the rear, you can bust some sweet drifts and drive right out no problem. I wouldn't try bad tires on the front though. Other systems use electronic sensors and have a front bias giving 80+% to front wheels while giving rear varying amounts when the front loses traction. It reacts much slower and there is probably a bit of over/under correction from the control system if the tires don't have even traction. I could see this leading to a quickly cycling clutch that would over heat your system.
Re:Print this file, your printer will jam (2008) by Dylan16807 on Saturday December 26, 2020 @04:32PM (#25546602)
> In all my research it turns out you need tires of the same size within 3/16 wear of each other to avoid non-full time AWD transmissions from doing dumb things like my car does.

9/32 + 3/16 = 15/32 so I guess not

Re:Print this file, your printer will jam (2008) by bayindirh on Saturday December 26, 2020 @05:42PM (#25547017)
Opel Calibra is extremely sensitive to asymmetric tyre wear. The speed difference damages the third, central differential. To prevent the problem, you need to rotate your tyres periodically.

It’s one of the main reasons why that car is notorious in terms of maintenance.

Too bad, I love that car though.

Re:Print this file, your printer will jam (2008) by aidenn0 on Saturday December 26, 2020 @03:20PM (#25546168)
I don't know if it does or does not actually cause issues, but the manual for my friends Subaru definitely says the tire wear needs to be even (possibly in pairs?). It came up when she got a nail through one tire about halfway through the lifetime.
Re:Print this file, your printer will jam (2008) by o-__-o on Sunday December 27, 2020 @10:08AM (#25551516)
Ugh this is my story right now. $500 cost for a new tire. I will probably get it patched and then put on a set of winter wheels while I figure out the next step