News for hackers. Stuff that matters.
Re:Coming soon: Google Fiber 2 Gig by toast0 on Wednesday November 11, 2020 @02:10PM (#25061713)
Depending on the age of your house, and how future proof they were; most houses have a phone jack in most of the rooms. If they were run since the mid-90s, it's probably 4-pair cat3 or cat5, and if you're lucky it's run to a central point that's accessible. Reterminate with rj45 instead of rj11 and boom. If it's 4-pair daisy chained, you'll need to put in two ports at each faceplate and jumpers in rooms you don't use and switches in rooms you do use.

Cat3 doesn't meet the spec for GigE, but in short runs without a lot of crosstalk from dense wiring, it's likely to work and worth a try.

If you only have 2-pair wires in the wall, you can still likely run 100BaseTX, which is OK if not very exciting. At least you'd remove most of the jitter of wifi.

If you're in a rental, I dunno how the landlord would feel about you messing with the jacks, but it's undoable. If you were considering pulling new wire, you likely own.

Re:Coming soon: Google Fiber 2 Gig by balls187 on Wednesday November 11, 2020 @04:15PM (#25063074)
Thanks. I neglected to mention that my home uses Cat5e for phone, but as far as I can tell, there is no central point that I can access.

I do own, so I don't mind running wires. Though I am being honest, back in 2003, I ran my own Ethernet in my apartment from the main room to my office.

I looked at thin ethernet to run under the carpet, but I am basically going from the main entrance (where the TV/Cable Modem reside) to the opposite end of the townhome, where my office is.

Prior to wires, I'm going to try the wifi6 mesh system from linksys. If I can get ~500-600mb/s to my office, that is a worth tradeoff.