Modern microwave knobs are not properly analog. They are so infuriating - an analog control fiddling with a discrete setting. As you turn the knob, it will occasionally (with no haptic feedback) tick over to the next discrete value.
In the time before baby, the analogue microwave was refreshing, now it's a nuisance.
It wasn't a huge deal when it happened to me because I wasn't very distracted and I was making tea so it just sat there and boiled for a couple of minutes until I checked in. Under slightly different circumstances it could have been much worse.
Not sure about your microwave, but mine (ca. 1996 Panasonic) has an analog knob (actually, that's the only control) for time.
If I need less than a minute, I turn the knob past 1 minute, then turn it back where I want it. That pretty much always works for me.
Perhaps it might for you too.
I have hated every microwave since.
https://www.ebay.com/i/203083047312
A closeup picture of the dial:
https://i.ebayimg.com/images/g/aogAAOSwFmZfPquw/s-l1600.jpg
The log-factor wasn't as severe as I had remembered, but the 0-1m angle is about the same as the 20-25m angle. It was still pretty easy to get 15s, 30s, etc. I'm sure you could do a lot better with modern digital electronics.
The analog knob you're referring to, I think, is the _very_ old design that functioned more like an egg timer. It was spring loaded and simply turned on the microwave circuit and broke it when the timer mechanically reached resting position.
The new knob is digital, and you use it to navigate a digial menu and to increase/decrease the timer prior to pressing it inward to start the process. Completely novel input mechanism.
Given that millennial seems to refer to anyone born between mid 70's and late 90's, that could basically be any type of microwave design that ever existed.
If you cut at mid 70's you'd basically be erasing Gen X, but just because it's popular to talk about "boomer" vs. "millennial" doesn't mean they're adjacent!
I don't have a microwave anymore for almost a decade now, but even before I used it occasionally only, mostly for heating up food from the day before, nothing where I'd need sub-millisecond accuracy. Also in general food tastes different/weird if you blast it at full power, so going for lower wattage and longer cooking times would reduce the need for super accurate timing controls. Unless you grew up on microwaved food exclusively, then I guess food prepared on a stove tastes weird. :-)