News for hackers. Stuff that matters.
Re:Creality Developing Belt-Driven Desktop 3D Printer by cfeduke on Sunday September 06, 2020 @05:39PM (#24394885)
I print a lot of miniatures which require tons of supports, but the support process most people in my space use result in supports that are incredibly easy to remove - it got to a point for me where I enjoyed removing supports that I was printing too much. Sort of like when we'd put Elmer's glue on our hands just to pull it off after it dried back in school. :)

Post (or pre) support removal is an isopropyl or acetone (or other agent) bath to remove any liquid surface resin and then a final UV curing.

I use an Anycubic curing station so that definitely speeds things up. To process a full build plate from my EPAX X10 it takes upwards of five minutes of my time [in terms of attention] (plus six minutes in the alcohol bath and six minutes in the UV cure chamber, which are both unattended processes).

Re:Creality Developing Belt-Driven Desktop 3D Printer by mrfusion on Sunday September 06, 2020 @06:03PM (#24395018)
Interesting. How much faster is the print time vs fdm?
Re:Creality Developing Belt-Driven Desktop 3D Printer by sydd on Monday September 07, 2020 @03:58AM (#24397516)
It really depends. an LCD resin printer prints a single layer at once, but it prints much smaller layers than an FDM printer (resulting in better quality). So for something small like a minifigure FDM will be faster, but for something big (especially if it has lots of small features) resin is faster usually. And resin prints are always more detailed.
Re:Creality Developing Belt-Driven Desktop 3D Printer by johnwalkr on Sunday September 06, 2020 @11:50PM (#24396488)
It's much slower than FDM (at least in my experience using a formlabs printer).