There's post-processing if you do prints that require supports (overhangs, etc). I've gotten good at designing within the constraints of the process to eliminate that as much as possible, but yes, it's still a pain.
A typical advantage of SLA over FDM or SLS is a smoother surface finish. But I think the industry will ultimately land on a material jetting design (akin to an inkjet) that can dispense multiple types of polymers and dissolvable supporting material. The NexD1 had promised to be the first consumer-grade printer to do this but it was a scam.
Post (or pre) support removal is an isopropyl or acetone (or other agent) bath to remove any liquid surface resin and then a final UV curing.
I use an Anycubic curing station so that definitely speeds things up. To process a full build plate from my EPAX X10 it takes upwards of five minutes of my time [in terms of attention] (plus six minutes in the alcohol bath and six minutes in the UV cure chamber, which are both unattended processes).