Re:Lunar – macOS utility to set brightness and volume on ext...
by arghwhat on Tuesday September 01, 2020 @04:22PM
(#24346588)
NAND Flash is just a type of EEPROM.
Early EEPROM could only be wiped entirely (but as this was done electrically, it was still an improvement over UV-erased EPROM), while EEPROM at the time of Flash's creation could often be byte-erased (as is the case now).
Nowadays "EEPROM" mostly refers to small, slow, rarely written config storage for microcontrollers. As thus, they are also usually accompanied by low write/erase endurance despite their byte-erase granularity.
Flash was meant as a higher capacity/performance version indeed sporting full block erasure as a downside, but nowadays it has supplanted EEPROM in all categories but small micro-controller usages. Plus, as capacity is now cheap, high write loads can easily be supported with write levelling (that is, writing to new locations instead of erasing/writing the same block over an over.)
Early EEPROM could only be wiped entirely (but as this was done electrically, it was still an improvement over UV-erased EPROM), while EEPROM at the time of Flash's creation could often be byte-erased (as is the case now).
Nowadays "EEPROM" mostly refers to small, slow, rarely written config storage for microcontrollers. As thus, they are also usually accompanied by low write/erase endurance despite their byte-erase granularity.
Flash was meant as a higher capacity/performance version indeed sporting full block erasure as a downside, but nowadays it has supplanted EEPROM in all categories but small micro-controller usages. Plus, as capacity is now cheap, high write loads can easily be supported with write levelling (that is, writing to new locations instead of erasing/writing the same block over an over.)