In practice it doesn't matter. For example, the floor of my bathroom is ten feet wide. I recently had to replace it, which in practice meant I had to cut a plank 9 feet 11.5 inches on one side and 10 feet 0.25 inches on the other side. It seems that the original carpenter, when dividing his plank by 3, eyeballed it it more or less so it looked right and just sort of waved their saw in the general direction of correct. It turns out that in reality, the actual arbitrary units are irrelevant.
But you know, bikeshedding on which arbitrary system of units is best is a pretty effective way to procrastinate finishing off that bathroom renovation.
A lot of the arguments though (and some of the most impassioned) mostly boil down to “I’m more familiar with this system so I assume it’s better” - for example, any time that people say that customary units are “more human scales” or “fractions are easier to understand than decimals” whatever. It actually makes basically no difference in practice, it’s just that growing up with one system or the other makes you a lot more familiar with it!
Essentially boiling down to the famous "easy vs simple" where something is "easy" if you're familiar with it and can draw conclusions via leveraging existing experience and "simple" is that it's maybe not familiar, but easier to become familiar with because it's not complex.
Blatantly stolen from Rich Hickey's "Simple Made Easy" talk: https://www.infoq.com/presentations/Simple-Made-Easy/
I think the foot is the only unit that is useful, otherwise converting between inches/feet/yards/miles get a bit ridiculous.
Also doing mathematical operations gets weird if you have to add/subtract 4' 3/4" and 2' 1/8".
Surveyors, the subject of this article, actually use decimalized feet on their rods (IIRC) given the errors that inches and such can add. So while inches-feet may be useful in the wood shop, in other places it's a problem.
In general, the secret to happiness in customary units is to only ever work in a single unit and never convert between them. If you are working in construction, you probably only ever want to deal in inches. Ceilings are 96 or 120 inches tall, doors are 32 or 36 inches wide, etc etc etc. The moment you start using two units at once you are going to have a bad time, so if you pay attention people tend to only use one, even if it confuses people who don't know why doors are 80 inches high instead of 6 feet 8 inches.
Do people really have to be fully acquainted with the US culture and/or have done full research on Wikipedia before asking a question for them to be taken seriously?
Ten only lets you get a half or a fifth. It's a much sparser set of subdivisions.
The same is true if you compare a yard with a meter. There's nothing wrong with either measure, but a yard gives you a lot more factors to work with.
For instance, over here the standard size for a sheet of plywood is 1200 x 2400 mm.
If you are working with some DIY task and everything is in Imperial measurements then it all works out as easy as Lego pieces.