News for hackers. Stuff that matters.
Re:We built a new GPS receiver engine by detaro on Tuesday May 19, 2020 @11:07AM (#23235649)
Do you happen to know a good introduction to how one would use it? I've looked at tools around it a few times, but always didn't find the point where it made "click" on how to actually do anything with them.
Re:We built a new GPS receiver engine by detaro on Tuesday May 19, 2020 @11:46AM (#23236139)
Thank you!
Re:We built a new GPS receiver engine by oyvind on Tuesday May 19, 2020 @02:40PM (#23238451)
Take a look at rtklib.com for software and instructions on https://wiki.openstreetmap.org/wiki/RTKLIB. There are quite a few u-blox receivers that work, also receivers from other brands. If you want to try dual frequency for improved accuracy, u-blox launched an affordable dual frequency chip in 2019.
Re:We built a new GPS receiver engine by danisth on Tuesday May 19, 2020 @11:48AM (#23236172)
You set up the base station over a known point, and now your rover unit can give you cm level accuracy when it's within range of the base station (UHF radio range generally).

For a practical application, let's say you wanted to lay out crops for a small hobby farm. This can make getting your base station set up, because you might not care as much about absolute location, which would require finding a surveyed benchmark. Instead you put your base exactly on the corner of your plot, and after setting up a local grid system you can now exactly layout your farm according to your plan. You simply walk around with the rover unit and can get real time cm accurate "coordinates."