News for hackers. Stuff that matters.
Re:What can a technologist do about climate change? (2015) by _Microft on Tuesday May 12, 2020 @11:25AM (#23154969)
Thanks for sharing, very nice!

Average power is 3kW for the setup producing 5kg per hour from what I understand. How much power is used for the electrical heating elements? Beside insulation, could waste-heat from cooling the filament be re-used to reduce power consumption, e.g. by using it to pre-heat the pellets in the funnel that feeds the machine (I'm aware that the phase transition will (most likely) require a lot more energy than heating the material to its melting point).

PS: the video was reversed, right?

Re:What can a technologist do about climate change? (2015) by econcon on Tuesday May 12, 2020 @11:42AM (#23155199)
300w*3 power usage is below 3kW.

It's in this article:

“Building Filament Extruder” https://medium.com/endless-filament/building-filament-extrud...

I didn't accurately measure it. My way of measurement is simply to run the extruder use current rating from clamp meter and multiply that by line voltage. So I guess the power usage goes down once heater reach target temperature. It's by no means accurate, only guarantee there is that the power usage will be below 3kilowatt.

Unfortunately I don't have good meter, the ones I order from AliExpress didn't arrive yet due to Coronavirus lockdown issues.

>Beside insulation, could waste-heat from cooling the filament

I've no idea. I've a water bath which in which there is a motor which simply moves the water from bucket into the bath then back the bucket.

>PS: the video was reversed, right?

No, the filament goes behind the spool so it appears as if the spool is unwinding.