PS: I once noticed my Sega genesis was producing a vary fuzzy picture, so I went to fiddle with the cable and noticed it was not even plugged in. At the time I really freaked out and to this day I still wish I had a picture.
Back in college, we were watching a, umm, adult video on my roommate's VCR. The guy from the room next door walked past, and said "oh, you're watching the movie too?". It turns out that we'd mistakenly connected the VCR's RF output to the antenna, so the guy next door was watching our transmitted movie. (although his picture was poor)
Sticking up almost any wire more than a few wavelengths long will collect a reasonable amount of a strong signal. A truly resonant antenna for the frequency you're interested is a lot better, but not that helpful for general HDTV viewing where the frequencies range all over VHF and UHF.
One of the amazing things I've learned from years of ham radio is how many unseen and unpredictable things affect radio signals. You can move your antenna twelve inches to the left and lose a signal completely, especially inside a structure. Or an airplane flying overhead can reflect enough "multipath" signal to wreck your TV viewing for 30 seconds. Of course your own body blocks a lot of signal and is capacitively coupled to the antenna system as you adjust it. So if you're playing with an HDTV antenna and are too young to remember the fun of constantly adjusting TV rabbit ears, just keep tweaking until you get a good signal.
Too young, ha! I use rabbit ears on my HDTV (no cable, just netflix + locals is enough for me) and laugh when I go to Best Buy and see "state of the art high definition" antennas for anywhere from $20 to $100. The same laugh hits me when I go down the gold plated monster cable isle, but that's a different story.
It's an interesting pricing model, and the $20-$60 cables more than paid for themselves after a single tour. Probably not appropriate for casual use though.
Like with the cables, neither makes sense. I could just buy one cheap cable from a reputable brand and probably not need another for 30 years.
And if I do? I'll just buy another. Because they're cheap and work perfectly.
And I know what I'm doing next time I'm at the mall.
Is he doing it right? Should the cables fail after every show? Shouldn't he just get better cables?
2. The shielding is there to keep signal interference out, which is useful if you have a clean source to start with (ie: Cable TV or a properly designed antenna). In my case, I just wanted to pick up as much signal as possible, and this is what I had to work with.
2. It's not shielded because the entire thing is the antenna. I guess he could shield it between the TV and the actual wrapped tube part but this is sow low-tech it wouldn't make a difference. Your standard roof mounted antenna is shielded between the antenna and the tv because you don't want interference between the two points.
To clarify this, with a roof mounted antenna the wire needs shielding because it is typically running down the middle of the house and thus would be subject to interference from the many electronic devices therein.
With this guy's solution, the wire just runs out of his window, and therefore as long as he doesn't have any ageing analogue equipment (speakers, cordless phones etc) near his TV or his window the issue of interference is minimal.
Two questions:
1. What exactly is the purpose of the cardboard tube? I'm guessing the key point is that it's non-conductive, but would the same coil work without the cardboard? (not very knowledgable about antennae I admit)
2. How the hell does that connector even work? It looks so marvelously out of place ... does this mean the wire mesh around the normal coaxial cables is just shielding and doesn't actually do anything? If so, how come you don't need shielding?
Those were the two main questions that popped to mind, obviously I don't know anything about this stuff and I could probably look it up somewhere. But maybe someone here can provide a human-to-human good enough explanation.