Yes, these devices are of a lower quality than devices with prices 10-100x higher, but they get the job done, which is what actually matters. Some new practices will have to be designed to properly decontam and maintenance them, and experimentation to figure out their tolerances, but there are many more medical practices in the world that need these devices than have them; the main issue is cost.
Working in hospital infection control, this was one of my first concerns as well.
In a lot of industries there’s a huge conflict of interest as the auditee is also the company paying the auditors.
If the auditee loses a certification / accreditation, that’s also a loss of business for the auditor.
A bunch of simple medical devices (Class I in the EU) are self-certified by manufacturers, and require no seal of approval before commercialization.
>For all devices except Class I, implement an ISO 13485:2016 under the Medical Device Single Audit Program (MDSAP) compliant quality management system, which includes the specific requirements of the CMDR. ISO 13485 certification, used to demonstrate compliance with European regulations, does not meet Canadian requirements. Updates to the existing procedures, or new procedures, must be implemented.
So it seems you don't need to implement post market surveillance for a class 1 device or having a complaint handling unit.
[0] https://www.emergobyul.com/resources/canada-process-chart
The research (self) validation [1] talk about similar performances than an existing product.
However, it does not talk about bio compatibility of the material used, potential contamination during manufacturing process, what kind of disinfectants can be used on the product, what is the operating range in terms of pressure, temperature, humidity, etc
A proper medical device manufacturer is also supposed to have a complaint handling unit, to raise and analyze every adverse effect on the field, and report to regulatory bodies the worst hazardous case in a limited time frame, be able to do recall and so on.
So I believe that this coming from the Gaza strip is a real boon because you don't have any other choice, but it does not mean that you could translate that model everywhere in the world.
Edit :
it seems this is registered as a Class 1 medical device in Canada, so it is possible that all my previous point have been addressed (still I am not quite sure how you can validate only a design without the manufacturing/shipping part) I am working on a Class 3 device so it is possible I am more paranoid that I should be...
>> In Canada, it is produced by Glia as a Class I device. Glia holds a Medical Device Establishment License from Health Canada.
I am not sure how you could pass an audit if your documentation contains "Lorem Ipsum" [2]
[0] The homepage mentions medical Hardware, but this page https://docs.glia.org/ still talks about medical device
[1] https://glia.org/stethoscope/
[2] https://docs.glia.org/docs/stethoscope/manufacturing/