News for hackers. Stuff that matters.
Re:A 3D Metal Printer Is Churning Out Rockets by imglorp on Tuesday October 29, 2019 @08:34AM (#21386392)
Is this assuming some of the materials are available there? This would make sense if you're getting fuel or metal from asteroids, moon's surface, etc and building ships near those. But in Earth orbit, you'll need to lift the shipyard, then the fuel, then the metal powder etc for sintering, so what would be the gain?
Re:A 3D Metal Printer Is Churning Out Rockets by mattlondon on Tuesday October 29, 2019 @09:22AM (#21386793)
You could construct things that wouldn't fit inside the nosecone of a launch rocket if you assemble them in orbit.

You could also repair/refit things without them having to go through re-entry and then be launched a second time E.g. replace damaged/worn out rocket cones or solar panels etc if you can build them in-situ. Imagine Earth-Mars shuttles that just go back and forth that would need maintenance

Re:A 3D Metal Printer Is Churning Out Rockets by adrianN on Tuesday October 29, 2019 @08:53AM (#21386531)
Lifting many small things is easier than lifting one Battlestar Galactica sized thing.
Re:A 3D Metal Printer Is Churning Out Rockets by jacquesm on Tuesday October 29, 2019 @10:15AM (#21387388)
Also, if it goes wrong the damage is limited, and likely fixable.
Re:A 3D Metal Printer Is Churning Out Rockets by mkl on Tuesday October 29, 2019 @08:53AM (#21386529)
Yes, you'd probably want to go get some asteroids. Even small ones can contain huge amounts of metals, and icy ones could be turned into fuel. There's a lot of potential, but it's all a bit out of reach for the moment. https://en.wikipedia.org/wiki/Asteroid_mining
Re:A 3D Metal Printer Is Churning Out Rockets by HeyLaughingBoy on Tuesday October 29, 2019 @02:25PM (#21390473)
Still, the concept of space mining is slowly becoming a thing: https://space.mines.edu/
Re:A 3D Metal Printer Is Churning Out Rockets by JoeAltmaier on Tuesday October 29, 2019 @09:12AM (#21386701)
Isn't moon dust mostly bauxite? (oxidized aluminum)
Re:A 3D Metal Printer Is Churning Out Rockets by mkl on Tuesday October 29, 2019 @09:22AM (#21386795)
Not exactly https://en.wikipedia.org/wiki/Geology_of_the_Moon. I think the problem with moon resources is the moon's gravity while forming was strong enough to pull metals like iron and nickel down into the centre where we can't get at them (they're on the surface a bit too, but not conveniently concentrated). Asteroids, on the other hand, can contain lots of accessible nickel, iron, cobalt, etc.

I'm no expert though!

Re:A 3D Metal Printer Is Churning Out Rockets by ben_w on Tuesday October 29, 2019 @09:48AM (#21387089)
Wikipedia looks like it says [0], by elemental concentration, roughly 42% oxygen, 21% silicon, 12% iron, 8% calcium, 7% aluminium, 6% magnesium, 4% other.

[0] Bar graph with insufficient labels: https://en.m.wikipedia.org/wiki/File:Composition_of_lunar_so...

Re:A 3D Metal Printer Is Churning Out Rockets by imglorp on Tuesday October 29, 2019 @10:22AM (#21387465)
Magnesium should be even better for some space apps. In fact, it would sinter better in a vacuum than air.

https://www.deepdyve.com/lp/wiley/sintering-of-magnesium-h06...