News for hackers. Stuff that matters.
Re:Pedestrian Bridge Collapse over SW 8th Street in Miami [pdf] by userbinator on Tuesday October 22, 2019 @11:58PM (#21330927)
If I'm reading the report correctly, the bridge was barely sufficient to support its own weight, which is extremely surprising since I remember reading a very long time ago that bridges and other structures are designed to be 10x stronger than they normally need to be; a vague reference in the article https://en.wikipedia.org/wiki/Factor_of_safety supports that. It seems like this bridge was designed for minimal cost...
Re:Pedestrian Bridge Collapse over SW 8th Street in Miami [pdf] by jaclaz on Wednesday October 23, 2019 @05:46AM (#21332909)
No, bridges (usually, but it depends on countries/national regulations and on the nature of the structure) have an overall design factor of safety between 1.2 and 1.8, in some cases 2, but the actual presumed loads are already increased (i.e. the calculation loads are more than what will actually happen) and there are some "implicit" safety factors in the use of materials, so that the overall "real" factor of safety usually is between 2 and 3.

The highest required factor of safety in engineering is AFAIK 5 and is used for things like lifts, cablecars and similar.

Re:Pedestrian Bridge Collapse over SW 8th Street in Miami [pdf] by abduhl on Wednesday October 23, 2019 @08:52AM (#21334065)
Factor of safety in the way that most people understand it has gotten increasing difficult to tease out since the switch to load and resistance factor design (LRFD) over allowable stress design (ASD) for most structures. I think timber is the only one which still defaults to ASD for permanent construction.

But the short version of the story is that for LRFD there are two main factors which affect “factor of safety” in the traditional sense (eg - structural capacity / structural demand) which are load factors and resistance factors (as you’d guess). Load factors increase applied forces while resistance factors decrease assumed strengths. Load factors vary depending on the type of load but typically they’re between 1.2 to 1.6. Resistance factors vary based on failure mechanism under consideration and are between 0.6 to 0.9 for structural work.

So the range is 1.2/0.9 to 1.6/0.6 or ~1.35 to ~2.75.

There are secondary sources of additional factors of safety. For example, material properties assumed in design are the minimums that are allowed and so chances are you’ll get something on site that exceeds by 25-50% or so because nobody wants to deliver material that doesn’t meet the minimums and open themselves to claims liability. There’s also a redundancy factor which is touched on in the report where loads are increased if no redundant load path exists, for concrete there’s some additional caps/limitations on a couple values due to time effects like creep, etc.

I would say most modern construction has an overall factor of safety of 3-5 with bleeding edge construction sitting at around 2 and public works construction (utilities or highways - things where architects aren’t involved) at over 5.

Re:Pedestrian Bridge Collapse over SW 8th Street in Miami [pdf] by sitharus on Wednesday October 23, 2019 @12:05AM (#21330943)
This is totally hearsay, but I've heard from multiple older engineers that as computer models have been improved over time the safety factor has been reduced as we have more accurate simulations. If the safety factors from the '50s had been used it's possible this bridge would never have been designed the way it was.
Re:Pedestrian Bridge Collapse over SW 8th Street in Miami [pdf] by jaclaz on Wednesday October 23, 2019 @05:30AM (#21332834)
The (approximate) rule of the thumb is that anything in reinforced concrete calculated by "hand" has an "implied" additional safety factor of 5-10%, mainly due to roundings by excess in the calculations, at least this has been my experience in the mid 1990's, when for a couple of bridges existing hand made calculations had been re-made with computers.

It is a small (but good) thing, though it would have IMHO not been enough to save this particular bridge, here the issue is evidently a wrong static model, or - less likely - a wrong assessment of loads.

Besides the initial (huge) calculation error, what is really preoccupying is that they didn't consider as serious the cracks, which as seen in the video/photos on youtube are the typical (severe) shear cracks, that should have been ringing all alarms.

The poor structure, as often happens, did all it could to "signal" the issue, what I find bordering being criminal is ignoring or severely underestimating those clear signals.

Re:Pedestrian Bridge Collapse over SW 8th Street in Miami [pdf] by dredmorbius on Wednesday October 23, 2019 @03:07AM (#21331926)
I've noticed from videos of recent bridge failures (FIU and the Taiwain Arch Bridge collapse a few weeks ago) how fast the failures occur. Contrast with, say, the Tacoma Narrows bridge failure in the 1940s.

I suspect current designs are far nearer critical tolerances. Even under the ridiculous dynamics of the Tacoma Narrows incident, ultimate failure took hours.

Re:Pedestrian Bridge Collapse over SW 8th Street in Miami [pdf] by userbinator on Wednesday October 23, 2019 @08:18AM (#21333779)
Even under the ridiculous dynamics of the Tacoma Narrows incident, ultimate failure took hours.

It took 4 months from construction to failure, during which time it was already flexing far more than normal.

Re:Pedestrian Bridge Collapse over SW 8th Street in Miami [pdf] by dredmorbius on Wednesday October 23, 2019 @09:07AM (#21334203)
The FIU and Taiwan's Nanfang'ao Bridge collapse (https://en.wikipedia.org/wiki/Nanfang%27ao_Bridge) each precipitated in seconds.

Contrast Tacoma Narrows, whose final throes were long enough for crowds to form and traffic to be cleared.

Tacoma:

https://youtube.com/watch?v=mXTSnZgrfxM

FIU:

https://youtube.com/watch?v=BSq8295GFk4

Nanfang'ao:

https://youtube.com/watch?v=mjsZbbG5fag

Morandi, Genoa, Italy:

https://youtube.com/watch?v=_gEMep8xLHk

I-35W, Minneapolis, MN:

https://youtube.com/watch?v=74JNl5n-YdI

Re:Pedestrian Bridge Collapse over SW 8th Street in Miami [pdf] by catalogia on Wednesday October 23, 2019 @01:50AM (#21331481)
Engineers are taught that anybody can design a bridge, but only a skilled engineer can design a bridge that barely stands.

https://hn.algolia.com/?query=bridge%20that%20barely%20stand...