Re:Flash Memory Wear Killing Older Teslas Due to Excessive D...
by metalforever on Tuesday October 15, 2019 @09:39AM
(#21258204)
Someone that has had a few classes in electronics should be able to replace this.
[ Parent
| on HN ]
Re:Flash Memory Wear Killing Older Teslas Due to Excessive D...
by SXX on Tuesday October 15, 2019 @09:55AM
(#21258353)
Unless your car has DRM that prevents you from tampering with it's flash memory...
Re:Flash Memory Wear Killing Older Teslas Due to Excessive D...
by spinach on Tuesday October 15, 2019 @10:11AM
(#21258504)
Seems a bit more complicated than just unsoldering the old chip and putting in a new one.
https://web.archive.org/web/20190621052637/http://teslaservi...
Re:Flash Memory Wear Killing Older Teslas Due to Excessive D...
by joezydeco on Tuesday October 15, 2019 @10:46AM
(#21258972)
However, if it's similar to how Apple does it, the chip might be bound to the processor via a serial number or some other magic that's burned into the NAND at manufacturing, or OTP on the processor, or something else.
It's not just a matter of "oh just go get a Hynix NAND part from DigiKey and reball the PCB". At minimum you need to copy the data over. At worst you need to bless the part with whatever secret sauce Tesla is using at the factory.
Re:Flash Memory Wear Killing Older Teslas Due to Excessive D...
by Avamander on Tuesday October 15, 2019 @10:08AM
(#21258482)
It takes more than that to replace a BGA flash chip.
Re:Flash Memory Wear Killing Older Teslas Due to Excessive D...
by lightedman on Tuesday October 15, 2019 @11:50AM
(#21259745)
A BGA can be replaced with a freaking heat gun from Home Depot and some solder braid and some flux.
Source: I used to repair cable boxes for CTDI. While everyone else is using their Metcal station and wasting 5 minutes, I've got the BGA off, board deballed, and a new BGA package installed and ready for PKI in less than 45 seconds with a heat gun.
Re:Flash Memory Wear Killing Older Teslas Due to Excessive D...
by cptskippy on Tuesday October 15, 2019 @10:22AM
(#21258662)
Not that much. BGA chips aren't that hard with a hot air station. I've done plenty of de-soldering and reflow using just a hot air gun.
Re:Flash Memory Wear Killing Older Teslas Due to Excessive D...
by rasz on Tuesday October 15, 2019 @01:11PM
(#21260927)
Not really, you can learn to handle BGA in 4-7 days and $2-3K from some very best people in the business https://www.ipadrehab.com/index.cfm?Page=Practical-Board-Rep...