It seems to me that the outer metal sheet on the connector will prevent a "wrong" angle on the wafer.
Linus Tech Tips actually tested 10000 USB-C insertions: https://www.youtube.com/watch?v=OqtNleXhTRE
Spoiler: USB MicroB failed at 8000, USB-C was still working at 10000
All it takes is for one fragment if debris to get wedged in the wrong way, and now that port on your expensive device is broken irreparably.
It may have that durability during normal use, but I doubt that these tests account for being shoved in backpacks or banged around in potentially dirty environments. Most people I know don’t use their laptops in sterile labs.
There are very affordable (relative to the cost of a new laptop) online businesses specializing in this exact problem. But a skilled hobbyist (possibly with some advise from Youtube) or decent phone repair shop can do it too.
It's actually not that hard (put kapton tape around, remove old using hotair and tweezers, clean with flux and wick, solder new with iron or hotair, a compatible solder or paste, and lots of flux. Clean with spray/brush). Assuming you can source a replacement part, but between Digi-Key/Mouser, eBay and AliExpress that's rarely impossible.
Out of curiosity, what issues have you had with the charger/port of the Switch? I've had a Switch for a couple of years now, and the closest thing to an issue I've had with charging is that I can't use a less powerful charger (e.g. the one for me phone) effectively with it, but I basically knew that going in.
I guess if there is a possibility for that it is very low or I am very lucky.
1: https://arstechnica.com/gaming/2019/08/heres-why-nintendo-sw...
[0]: https://www.reddit.com/r/NintendoSwitch/comments/bjwpsy/nint...
I've just assumed those "warnings" are there for liability reasons because these companies didn't test their devices' charging capabilities across all possible USB charging devices.
I think the issues are more with poor quality chargers than the switch itself.
There have been problems with 3rd party doc which is partly Nintendo and partly 3rd parties.
https://arstechnica.com/gaming/2019/08/heres-why-nintendo-sw...
Aside from being a fragile and poorly designed physical connector, the state of protocols that can be run over it is a disaster. My grandmother definitely will not be able to troubleshoot why her devices don't work properly together when she uses a USB type C cable to connect Thunderbolt devices. I suspect this will be the same for many other users.
While having a ridiculous number of different connectors isn't great, I think it would have been reasonable to at least have different connectors for power, data, and video (even if they were all part of the same spec, and just keyed different to help end users figure out what to plug in where).
I would also have really liked to see a solid core connector. Apple Lightning is a good example of what that would look like -- there is no tiny wafer inside of the device-side port to crack, and both the port and connector are much more durable. Not that I think we should all use lightning, but it's an example of a reasonably well designed connector in my view.
Finally, I think the fact that so many vendors have failed to properly implement the spec is a sign that it's a bad spec. Raspberry Pi and Nintendo presumably have competent engineering departments. By and large, nobody had difficulty getting microUSB right.