Re:Casting Glass from 3D Printed Molds
by samplatt on Monday August 05, 2019 @11:58PM
(#20622001)
I'm curious about the too-rough-to-wear bit. Would an extra (leather/plastic) layer below the glass be impossible?
[ Parent
| on HN ]
Pâte de verre is typically rougher than kilncasting from a larger billet, because you're fusing glass granules without fully melting them together. So you could get a smoother surface just by adjusting the peak kiln temperature.
But yea, certainly you could add a leather wrap underneath.