> In general, losses are estimated from the discrepancy between power produced (as reported by power plants) and power sold to the end customers
[0] https://en.wikipedia.org/wiki/Electric_power_transmission#Lo...
A superconducor rejects magnetic fields (a bit like a Faraday cage). What if you cranck it up high enough and force the superconductor in place? You lose superconductivity.
For that reason, there is actually a limit to thew current that can be transmitted, though it is much higher than with conventional cables (you still can't power a city with a hair-thin cable, IIRC).
I'd still guess the bulk of the value would be in more local uses, but there are some interesting large-scale possibilities, including power transmission.
https://en.m.wikipedia.org/wiki/Electric_power_transmission#...
Consider the other losses:
- Thermal (gas turbine) cycle: 40-60% lost (the big one) - Transformer loss: 1-2%. You pay this every time you step up/down, so it adds up. - Capacitive coupling: I dunno, but length dependent. It has to be about the same as Ohmic losses since once it's large you switch to DC lines (and take an Ohmic loss hit from lower V) - You're house's power factor (which, unlike industrial users, you're not charged for).
[0] in the sixties very large V lines were introduced (0.75 - 1.0 MV ??). They work, but it's not considered worthwhile.
Point is, they're kinda useless for transmission.
[0] MRI magnets are superconducting for the efficiency of superconductors, not for the field strength! The strongest magnets are not made of superconductors but out of copper pipes: electrical conductors with coolant pumped through them!
A more didactic answer might start with defining power, P=IV (power equals current times voltage) and “ohm’s law” V=IR (voltage equals current times resistance) and suggest this means that the power lost to the resistance of transmission line with resistance R is P=I^2R. Since the current you send is proportion to the voltage (One megawatt can be 1Amp at 1000000 Volts or 1000Amp at 1000 Volts, you want to use as high voltage as possible when transmitting long distances. The limiting factor on voltage is the amount of insulation required.
Usually power transmission uses three-phase alternating current, which sends power by varying the voltage on three lines each 120 degrees (1/3 period) offset from one another. It’s reasonable homework to read about why AC is better for transmission and also how three phase AC works and determine the economic value of laying three cables instead of two, with variables for the cost of wire, fixed costs per mile, and cost of electricity. ~50% of transmitted power is used to drive three-phase synchronous AC motors.
Resistance is related to the resistivity (denoted with a Greek rho) of the material and the cross-sectional area (denoted A) and length (L) of the wire: R=rhoL/A Resistivity is a fundamental property of materials and is related to the free movement of the outer shell of electrons of atoms in a crystal lattice.
Superconductors do not have resistance and can carry an extremely large current as a result. Unfortunately superconductors have a maximum magnetic field capacity and require extremely low temperatures requiring cooling with liquid helium or nitrogen.
What is the level of (in)efficieny for say power lines? And power cords, etc around the office/house?
That is, of the electricity produced, how much is lost due to how it's transported? Does decentralizing production (e.g., solar panels on your own roof) help in any way?