News for hackers. Stuff that matters.
Re:Detroit’s LED streetlights going dark after a few years by dreamcompiler on Tuesday May 07, 2019 @06:31PM (#19854041)
It has to be a good source of direct current, literally. It has to produce a steady, constant amperage regardless of grid spikes and fluctuations. Given that the grid is AC, this requires a relatively complex circuit and more careful engineering than is commonly done for the power supplies inside bulbs.

Edit: Sometimes LED current is actually high-current AC with a square waveform, especially with dimmable bulbs. This is fine provided it's well-regulated and protected from spikes.

Re:Detroit’s LED streetlights going dark after a few years by jcims on Tuesday May 07, 2019 @07:28PM (#19854418)
This is complicated by the fact that the temperature of the LED materially influences its electronic properties.

As a result you generally need to wire them in series rather than in parallel so that the current can’t differentially select the LED of least resistance and cause thermal runaway. Series wiring in turn cranks up the voltage requirements necessary to drive lots of power, requiring more costly components.

Oh, forgot to mention, different color LEDs have different forward current requirements, so have fun building a good and cheap driver for 100W RGBW.

Re:Detroit’s LED streetlights going dark after a few years by Itsdijital on Tuesday May 07, 2019 @07:46PM (#19854552)
Sort of, but not really.

LEDs can easily be wired in parallel as long as you use resistors to balance them. If you dial in the voltage real tight you can get away with minimal losses in the resistors. If you are really fancy you can use transistors and shunts to actively balance then for even more efficiency.

The reason why series is more popular is actually because it is cheaper and(can be) more efficient. It's not uncommon for cheap led lights to just throw 40 leds in series with a dead simple "driver" (read: rectifier, smoothing caps, and a resistor)to run it right off 120V.

Re:Detroit’s LED streetlights going dark after a few years by rahimnathwani on Wednesday May 08, 2019 @12:29AM (#19855876)
Re: your last sentence, does that mean the whole unit dies as soon as one LED fails?
Re:Detroit’s LED streetlights going dark after a few years by jcims on Wednesday May 08, 2019 @01:54AM (#19856207)
Not the person you’re replying to, but yes. Series config you lose the circuit if the LED fails open and it shuts the whole string down naturally.

Similar issues can affect parallel. If one LED fails open and you don’t adjust the current, you’ll start overdriving the other LEDs and shorten their lives...potentially dramatically. You could add current sense and shut down the board or even adjust current, but then costs go up.

Typical LED strips are small serial strings of typically three lights connected in parallel. That way if something goes wrong you knly lose a few lights.

Re:Detroit’s LED streetlights going dark after a few years by acchow on Tuesday May 07, 2019 @07:09PM (#19854296)
Can we design an LED that isn't affected by typical city fluctuations and spikes?
Re:Detroit’s LED streetlights going dark after a few years by Itsdijital on Tuesday May 07, 2019 @10:05PM (#19855300)
I'm not sure where the OP is coming from because any halfway decent LED driver will accept a wide range of voltages, far more than the fluctuations seen on public lines.
Re:Detroit’s LED streetlights going dark after a few years by Itsdijital on Tuesday May 07, 2019 @10:23PM (#19855390)
LEDs themselves are very intolerant of voltage (well really current fluctuations, semi-conductors are weird), but that isn't an issue because the driver deals with that and large swings will kill the driver or kill the driver and LED.

LED tolerance doesn't really play into the scenario here. It's all about the driver.

Re:Detroit’s LED streetlights going dark after a few years by dreamcompiler on Tuesday May 07, 2019 @10:20PM (#19855373)
I think he's asking if LEDs themselves can be more tolerant, since the drivers built in to LED bulbs rarely even rise to the level of "halfway decent."
Re:Detroit’s LED streetlights going dark after a few years by pixl97 on Tuesday May 07, 2019 @07:39PM (#19854497)
If you can, I'm sure someone would pay you a lot of money for the design.