News for hackers. Stuff that matters.
Re:Making and Selling a Stair-Climbing Dolly by amelius on Wednesday December 26, 2018 @11:18AM (#18762835)
What makes this better than just a larger wheel in the right position?
Re:Making and Selling a Stair-Climbing Dolly by cydonian_monk on Wednesday December 26, 2018 @11:33AM (#18762953)
The multiple smaller wheels give an extra leverage point, whereas a single, larger wheel can require quite a bit of force. If climbing multiple stairs that can wear both you and the dolly out.

I'm not sure I would have preferred this back when I was still moving furniture for a living, as a furniture dolly with belts along the back/spine will slide up a flight of stairs without much trouble.

Re:Making and Selling a Stair-Climbing Dolly by DBYCZ on Wednesday December 26, 2018 @12:51PM (#18763430)
I used to move furniture and I much preferred the type of straps that would wrap around your wrists, under the appliance, to the other lifter's wrists over the furniture dollies.
Re:Making and Selling a Stair-Climbing Dolly by cydonian_monk on Wednesday December 26, 2018 @01:56PM (#18763913)
We tended to always be labor-short for deliveries, so if we could send a job out with one person we would. A single person can safely deliver most household appliances with just a furniture dolly (up to a side-by-side fridge, which almost always needed two people due to its mass and a set of tools to remove the doors).
Re:Making and Selling a Stair-Climbing Dolly by pbhjpbhj on Wednesday December 26, 2018 @01:46PM (#18763803)
Sounds like a good way to lacerate your wrist, or maybe lose your hand.
Re:Making and Selling a Stair-Climbing Dolly by amelius on Wednesday December 26, 2018 @12:56PM (#18763459)
If you're talking about wear then my gut feeling says that a larger wheel would be far more robust than three smaller wheels (with additional axis for the combination). Especially when you're using this on streets with uneven pavement I think a larger wheel would be better.
Re:Making and Selling a Stair-Climbing Dolly by pbhjpbhj on Wednesday December 26, 2018 @01:45PM (#18763791)
The larger wheel will be made of slightly too thin plastic and held on with a split-pin - how else will you resell it in 2 years - so robustness probably isn't a positive factor from the sellers perspective.
Re:Making and Selling a Stair-Climbing Dolly by roland35 on Wednesday December 26, 2018 @11:49AM (#18763060)
The axle needs to be higher than the ledge of the step. So basically that means the radius of the wheel needs to be larger than a normal step height, which would mean a giant wheel which may not fit on the step at all!
Re:Making and Selling a Stair-Climbing Dolly by oftenwrong on Wednesday December 26, 2018 @11:31AM (#18762941)
Larger wheel requires the axle to move up a larger vertical distance while being pulled up a step as compared to the compound wheel design
Re:Making and Selling a Stair-Climbing Dolly by spydum on Wednesday December 26, 2018 @11:31AM (#18762939)
i suspect the leverage of pivoting the tri-spoke axle helps transfer more of the horizontal force you are applying, into a vertical force as it pivots. A larger wheel doesn't do this the same way
Re:Making and Selling a Stair-Climbing Dolly by rasz on Wednesday December 26, 2018 @11:58AM (#18763126)
moves the leverage point across the step edge