Initially it's in a steady state where the target is colder.
You increase the number of photons hitting the target. The target gets hotter. All good so far.
But we have to look at how you increased that number. You need to either move the source and target closer together, or you have to use lenses to simulate the same thing.
You can keep hitting the target with photons from more and more directions, but no system of mirrors or lenses can increase the apparent brightness of the source.
As you approach the point where the source fills the entire sky, the target will approach the same temperature.
And then you can't increase the number of photons any more. Not without using a hotter source.
There is a limit to how small you can focus a lens. Once the object you are focusing is in sharp focus, it will start to go out of focus again if you go past that point. So you can’t just arbitrarily increase the photon density further.
If you make your lens bigger to gather more photons, then the focused image just grows by a corresponding amount.
Optics (and thermodynamics) tell us that we can not generate a higher flux of photons into a target area, than left the equivalent area at the source. Assuming that both the source and target are black body radiators, that says the target can’t get hotter than the source.
Say a light source has a T temperature resulting in X photons emitted. I redirect all the photons to a single point. I see arguments mentioning that that single point cannot be hotter than the source because there's no more photons to make it hotter.
I now add a second light source of the same T temperature, that emits the same amount of photons and also focus all of them on that same point. I now have more photons, but temperature source of all photons is the same. How does adding more photons not make my point hotter?
For that to be possible with a blackbody light source, it has to itself be a single point. Which means a temperature of approximately infinity.
For a real light source, one that has an area, you can at best focus it down to the same area. To get maximum light to a target, you either have to make the target almost touch the source, or you have to have it so no matter what direction you go from the target, you hit a lens that's bringing light from the source. Once you set either one of those up, there's nowhere to fit a new light source.
I'm not an optics expert, but this can't be true. You can clearly focus light emitting from an area into a smaller area (although probably not to an infinitesimally small area).
You can't increase the density of the light. You can't focus all of it onto a smaller area.
Is that clearer?
If that is the case, then there is no extra room to fit the optics to focus another source onto the target.
If you shrink the optics enough to make room for another source, then you also aren’t delivering all of the photons from the original source (you can’t be, since you aren’t covering all incoming angles), and therefore it’s not the same temperature as the source.
What about two single photon sources, can’t they be pointed at exactly the same spot? Maybe the explanation here is that the target electron cannot interact with 2 photons at the same time, so you can’t ‘double heat’ a single particle. Or maybe that you can’t precisely target a single particle without decreasing the entropy of a closed system, which is impossible.
I am dumping some amount of low-energy photons onto a target, the target is heated up and radiating out the same amount of energy it receives. As I increase the number of photons hitting the target its temperature raises and it radiates more heat outwards, shedding excess heat.
Then as I keep increasing the number of photons, the temperature stops increasing at some point having reached the temperature of the photon source. I increase the number of photons a million times of the previous level, yet the object remains the same temperature.
Where does the excess energy go? Is it not absorbed by the target? Is it reflected? Is it re-radiated?