Re:Metamolds: Creating ideal 3D printed silicone molds faste...
by virtualritz on Monday September 03, 2018 @08:03PM
(#17905659)
Re.: 1)
The latest generation of 'cheap' DLP printers can do 25 micron (e.g. the Phrozen Shuffle).
After curing, dipping in resin again or priming and then coating with 2-3 layers with an airbrush results in a perfect surface finish. No sanding required.
[ Parent
| on HN ]
Re:Metamolds: Creating ideal 3D printed silicone molds faste...
by mdorazio on Tuesday September 04, 2018 @02:54AM
(#17907120)
Are you actually getting a perfect surface finish that way? My Phrozen Make printing at 20 microns leaves noticeable lines and definitely requires cleanup around support attachment points. I tried doing the second dipping method and ended up with melty details on finer parts of prints. The only thing I haven't tried is sandblasting.
Re:Metamolds: Creating ideal 3D printed silicone molds faste...
by virtualritz on Tuesday September 11, 2018 @06:45PM
(#17964089)
The Make can't do 20micron. It can do about 47 max (or rather, min), I think.
Re-read my post: I was talking about the Phrozen Shuffle which has a different screen/display unit.
Check the FB group for some 27micron examples done with the Shuffle.
Re:Metamolds: Creating ideal 3D printed silicone molds faste...
by jjoonathan on Tuesday September 04, 2018 @01:06AM
(#17906787)
> 25 micron
Hey where did the 0.4 micron go?