Re:Metamolds: Creating ideal 3D printed silicone molds faste...
by virtualritz on Monday September 03, 2018 @08:03PM
(#17905659)
Re.: 1)
The latest generation of 'cheap' DLP printers can do 25 micron (e.g. the Phrozen Shuffle).
After curing, dipping in resin again or priming and then coating with 2-3 layers with an airbrush results in a perfect surface finish. No sanding required.
Re:Metamolds: Creating ideal 3D printed silicone molds faste...
by mdorazio on Tuesday September 04, 2018 @02:54AM
(#17907120)
Are you actually getting a perfect surface finish that way? My Phrozen Make printing at 20 microns leaves noticeable lines and definitely requires cleanup around support attachment points. I tried doing the second dipping method and ended up with melty details on finer parts of prints. The only thing I haven't tried is sandblasting.
Re:Metamolds: Creating ideal 3D printed silicone molds faste...
by virtualritz on Tuesday September 11, 2018 @06:45PM
(#17964089)
The Make can't do 20micron. It can do about 47 max (or rather, min), I think.
Re-read my post: I was talking about the Phrozen Shuffle which has a different screen/display unit.
Check the FB group for some 27micron examples done with the Shuffle.
Re:Metamolds: Creating ideal 3D printed silicone molds faste...
by jjoonathan on Tuesday September 04, 2018 @01:06AM
(#17906787)
> 25 micron
Hey where did the 0.4 micron go?
Re:Metamolds: Creating ideal 3D printed silicone molds faste...
by birdman3131 on Monday September 03, 2018 @04:37PM
(#17904744)
5)Have one of the $40k clip printers that don't leave the lines.
1) Use a resin printer and print the meta-molds at very high resolution, then lightly sand with high-grit paper or use a gap filling primer paint.
2) Use ABS, HIPS, or another acetone smoothable plastic and vapor bathe the meta-molds (would probably slightly mess up the split lines though).
3) Use a paint-on epoxy to manually smooth out the meta-mold interiors.
4) Manually sand as best as you can.
The normal process for this would be to print the 3D model you want and then do a bunch of post-printing cleanup and treatment to get it to mold-ready quality, then cast a silicone mold of that. It's not super fun, but you can get good results without years of practice.