News for hackers. Stuff that matters.
Re:Brilliant design: RCA student radically improves the UK plug by jacquesm on Tuesday October 12, 2010 @09:49PM (#1785726)
> You must deal mainly with very old poorly maintained houses (rentals?), because all those problems do not exist in normal outlets.

Rural areas, farmhouses, but one building I lived in in Toronto had a problem (a bad one) with one of the sockets and it was a fairly recent upgrade from what I remember.

> You have soot on your contacts???? Corrosion? Did it rain inside your house?

No, simply an installation from the 70's still operating in 2005. There are millions like that. And I don't live there anymore, I'm back Europe now.

> NEVER tighten aluminium contacts!

Not over-tighten, tighten. You should do it to the proper torque (there are special tools for that).

> But aluminium to the contacts is very rare in america these days, where it does exists it's usually been pigtailed with copper.

Yes, that's the slightly newer method, also since outlawed (and used as a way to fix problems).

The biggest problem I think with the alu wiring was not even that it could not work, but that people would use it with the wrong connectors, the al specific sockets were pretty pricey.

The only place where I know that aluminum is still used in residential wiring is on the entrance wire from the pole to the transformer, usually that's a very tricky connector that uses wedges to make the contact.

If I found myself in a house with aluminum wiring I'd probably rewire the whole thing just for safety. Costly (especially with the US system which staples cables to studs) but worth the peace of mind.

Re:Brilliant design: RCA student radically improves the UK plug by ars on Tuesday October 12, 2010 @10:55PM (#1785899)
No, I mean don't tighten it at all! Not unless you open it and add anti-oxidant. If you tighten it you break the air seal, and allow it to oxidize, and aluminium oxide does not conduct.

The correct installation uses anti-oxidant to seal it, then you tighten it enough to crack the aluminum oxide, and the anti-oxidant protects it. If you tighten it without fresh anti-oxidant you are creating a hazard.

And pig tails are not outlawed - quite the opposite, they are the recommended way to handle aluminium wiring.

Re:Brilliant design: RCA student radically improves the UK plug by jacquesm on Tuesday October 12, 2010 @11:00PM (#1785922)
> No, I mean don't tighten it at all! Not unless you open it and add anti-oxidant. If you tighten it you break the air seal, and allow it to oxidize, and aluminium oxide does not conduct.

Ah ok, I see what you mean now, yes that makes good sense.

As for the pigtails, as far as I know you can not make any new wiring with Aluminum in residential installations, pigtailed or not (I left my code book in Canada because it is of no use to me here, maybe there is some up-to-date online resource). Industrial use is still ok I believe.

Re:Brilliant design: RCA student radically improves the UK plug by ars on Wednesday October 13, 2010 @01:26AM (#1786187)
> as far as I know you can not make any new wiring with Aluminum in residential installations, pigtailed or not

Yes. But if you already have aluminium wiring you can - and should - add pigtails to it to make it safer.