Re:Brilliant design: RCA student radically improves the UK plug
by ramchip on Tuesday October 12, 2010 @09:00AM
(#1783156)
According to (http://www.faqs.org/faqs/electrical-wiring/part1/section-20....) and to the wiki article on wire gauges, 40A requires 8-gauge wire, which is 3.264mm in diameter, while 20A is 12-gauge, which is 2.054mm. The ratio of their cross-sectional area is 2.53; this justifies that the 40A wire conducts twice as much as the 20A but has 2.53 as much area, thus being more costly.
I'm not sure why. Is the skin effect sufficient to explain this?
Re:Brilliant design: RCA student radically improves the UK plug
by mturmon on Tuesday October 12, 2010 @02:40PM
(#1784398)
Skin effect is not a factor in 12AWG wire at 60Hz. It takes much higher gauges and/or higher frequencies.
Re:Brilliant design: RCA student radically improves the UK plug
by regularfry on Wednesday October 13, 2010 @05:01AM
(#1786581)
I doubt it's skin effect. More likely to be a safety margin so that it doesn't risk overheating.
Re:Brilliant design: RCA student radically improves the UK plug
by kjuhygtfrde on Tuesday October 12, 2010 @09:40AM
(#1783290)
Yes, a ring circuit you run a single wire around the room and back to the fuseboard. With a spur circuit you run a single wire to the furthest plug.
In a typical room going back to the fuseboard isn't much further so it's not twice as much wire - more like 10% more
Or did you mean that you only need to run one set of wire instead of multiple ones to multiple outlets?