News for hackers. Stuff that matters.
Re:Fully digital valves open up engine possibilities by tomatotomato37 on Sunday August 12, 2018 @06:24PM (#17746787)
I thought koenigsegg was already doing this with their freevalve thing

Also I saw an interesting point in an article about the koenigsegg thing that would pertain to this too; environmental laws would be much harder to practically enforce with this as you could run virtually any engine anemic enough to get though the emissions tests (and set it as the default mode to get around the Volkswagen nonsense) and then offer high/sport/cruise modes that runs the engine at full capacity otherwise

Re:Fully digital valves open up engine possibilities by nounaut on Monday August 13, 2018 @02:33AM (#17748381)
For those of you interested in seeing some more details on Koenigsegg's work with their freevalve engine:

https://www.youtube.com/watch?v=Bch5B23_pu0 (2013)

https://www.youtube.com/watch?v=S3cFfM3r510 (2016)

Re:Fully digital valves open up engine possibilities by TheSpiceIsLife on Sunday August 12, 2018 @10:42PM (#17747712)
> environmental laws would be much harder to practically enforce ... and then offer high/sport/cruise modes that runs the engine at full capacity otherwise

Only if your company is ready to willfully break the law.

The vehicle ought to, at the time of testing, meet or exceed all relevant standards, and not have a user accessible option to circumvent the standards.

Re:Fully digital valves open up engine possibilities by tibbon on Monday August 13, 2018 @02:08AM (#17748299)
Well there’s a car hacking then for a future Defcon tuning panel then... because if I buy it, I want to be able to hack and modify it in any way I want. As long as I’m not violating emissions, then it should be within the law

Thankfully, automakers have quite and uphill battle to actually make something secure and inaccessible, so I feel confident a solution would be found :)

Re:Fully digital valves open up engine possibilities by Pulcinella on Monday August 13, 2018 @09:10AM (#17749746)
This does happen now in car culture where people will tune it “chip[1]” their car to increase performance. In practice, it’s difficult enough (you can’t just do it through the car’s infotainment system) that your average driver won’t do it and it’s probably not to big of an empact on the environment[2] and people’s health[3].

[1]”Chipping” used to enclose physically replacing a car’s ECU but now it usually just means the control software has been chnaged digitally. [2]Unfortunately, some awful people will and do “roll coal” to purposefully increase emissions and smoke. It’s illegal in many places but difficult to enforce.

[3]Your car still has to pass emissions and sometimes people do bring the ECU back to stock firmware before annual inspections just to pass. Difficult to enforce but tuning usually sacrifices fuel economy for performance and its not simple to do. Most people who just want a grocery-getter won’t be trying it.

Re:Fully digital valves open up engine possibilities by thinkingkong on Sunday August 12, 2018 @07:20PM (#17747024)
Wouldnt the test just need to apply to all modes? If its a matter of automatically tuning through a series of conditions then its reasonable that those could be documented and tested by the facility / standards body.
Re:Fully digital valves open up engine possibilities by londons_explore on Monday August 13, 2018 @02:48AM (#17748423)
Efficiency testing of appliances (eg. Dishwashers) only tests the default mode.

That's why all dishwashers have a mode which takes 4 hours and does a lousy job. It's the mode that only uses 3 drips of water and a sip of electricity.

Re:Fully digital valves open up engine possibilities by photojosh on Monday August 13, 2018 @07:59PM (#17754574)
Do you have a link to any resource which talks about what the best way to use it? Everything easily searched seems to be how to get your dishwasher to run at its most efficient.

I've never had a problem with our one with it's 2.5hr eco mode, when running overnight (which is 90% of our loads). If we need a quick load during the day, we'll use the 40min cycle. Either way the wash quality seems the same.

Re:Fully digital valves open up engine possibilities by londons_explore on Thursday August 16, 2018 @06:29PM (#17778939)
I'm sure it varies widely by machine. Ours when on eco mode doesn't really dry the dishes (drying uses heat which uses electricity!), and only does one rinse to save water so dishes still have a bit of grime on them, especially if lots of the plates have thick gravy or anything on.

I would put eco mode as 'passable', but you have to remember to scrape off the plates well beforehand, rince especially gungy stuff (like porridge), and to probably do a bit of hand drying of items afterwards.

One the other hand, the 'intensive' mode only uses 50% more electricity, takes a quarter of the time, leaves the plates clean and dry every time, and uses a hotter wash temperature which I suspect is better at killing pathogens, and doesn't need any pre-rinsing or plate scraping beforehand. It's a no-brainer in my mind.

Re:Fully digital valves open up engine possibilities by yontherubicon on Sunday August 12, 2018 @09:46PM (#17747507)
Sure, but emissions testing after you've got the car would be utterly useless.
Re:Fully digital valves open up engine possibilities by londons_explore on Monday August 13, 2018 @02:51AM (#17748430)
The solution to this is to mandate that the car have built in emissions modelling.

The car itself must keep track of how much Nox it has produced and how many miles it's driven. The ratio must stay below some legal limit (or you pay an extra pollution tax to go over it)

Re:Fully digital valves open up engine possibilities by inferiorhuman on Monday August 13, 2018 @01:19AM (#17748156)
How so? Roadside emissions testing is very much a thing, as are annual emissions checks.
Re:Fully digital valves open up engine possibilities by HeyLaughingBoy on Monday August 13, 2018 @01:05PM (#17751609)
Not in all states. I haven't had to do it in 20 years.
Re:Fully digital valves open up engine possibilities by inferiorhuman on Monday August 13, 2018 @01:19AM (#17748155)
> environmental laws would be much harder to practically enforce with this as you could run virtually any engine anemic enough to get though the emissions tests

lol

Changing a cam (or cams) in most engines isn't all that difficult. Even without a camshaft you'll still be heavily limited by the shape and size of the combustion chamber and the geometry of the valves. You simply won't be neutering the engine that much.

Re:Fully digital valves open up engine possibilities by SmellyGeekBoy on Monday August 13, 2018 @05:04AM (#17748838)
Changing a camshaft in a classic car is huge pain that requires specialist equipment for setting the timing etc. and getting it wrong can destroy the engine. It's more than possible in a home setting but most home mechanics I know wouldn't touch them. I'm sure it's a lot more complicated on a modern car.
Re:Fully digital valves open up engine possibilities by inferiorhuman on Monday August 13, 2018 @10:43PM (#17755224)
> Changing a camshaft in a classic car is huge pain that requires specialist equipment for setting the timing etc. and getting it wrong can destroy the engine.

That's overstating the case quite a bit. There are plenty of engines where you don't need special tools.

> I'm sure it's a lot more complicated on a modern car.

Wait. You were talking about older engines? Then, no. You're absolutely wrong. Swapping out cams on most older engines is a piece of cake. Pretty much anything without variable valve timing will be super duper easy. Pushrod motors are especially easy. There are some exceptions, of course, like the DeLorean's V6 (the cams slide out of the head so you generally won't have room to pull them out without pulling the head).

Re:Fully digital valves open up engine possibilities by justinclift on Sunday August 12, 2018 @09:35PM (#17747481)
After market engine modding would be interesting too.