Re:Shapeways (3D Printing Startup) Raises $5MM Series A from...
by steveklabnik on Thursday September 23, 2010 @12:50PM
(#1720276)
While I certainly don't mean to dampen your enthusiasm, it takes more than open source culture to get those prices to drop. This industry is an absolute minefield for intellectual property. Just like 2D printing, 3D printing manufacturers make roughly 70% of their cash from the sale of materials, and this means there's no incentive for them to drop.
Of course, this isn't stopping people from knocking them off for cents on the dollar, but still.
Re:Shapeways (3D Printing Startup) Raises $5MM Series A from...
by dmvaldman on Thursday September 23, 2010 @12:59PM
(#1720312)
Yes but there is more than one reason to charge a lot for a product, one is the material used (which I don't expect to change much), but there are many others, such as creativity of design, utility, etc.
When you look at Shapeway's store you can see so much intricacy in some products. With a $10 block of plastic I can make a product that would otherwise sell for $100, now sell for $10.
Re:Shapeways (3D Printing Startup) Raises $5MM Series A from...
by steveklabnik on Thursday September 23, 2010 @01:31PM
(#1720465)
Trust me, I'm totally on your side. Theres a reason this tech has been around since the 80s, but things like the MakerBot has only happened recently, that's all I'm saying.
Re:Shapeways (3D Printing Startup) Raises $5MM Series A from...
by ghjklkjh on Thursday September 23, 2010 @02:44PM
(#1720770)
The reason is that the software was always very difficult (and expensive)
People that had, and could drive, Solidworks weren't interested in making one-off bits of jewelry and the artists that were couldn't drive the CAD system.
Re:Shapeways (3D Printing Startup) Raises $5MM Series A from...
by rdschouw on Thursday September 23, 2010 @01:23PM
(#1720418)
There are lots of industries riddled with IP and it is not stopping them to be huge and successful.
I think there are lots of opportunities in this market and prices will go down. But I think the whole ecosystem of 3D printing has to change to accomplish this. Maybe Shapeways can contribute to this.
But imagine if even a little of the "open source" culture rubs onto this community, prices could fall incredibly low for super interesting products. I can really see this taking off.