News for hackers. Stuff that matters.
Re:Shapeways (3D Printing Startup) Raises $5MM Series A from... by dmvaldman on Thursday September 23, 2010 @12:59PM (#1720312)
Yes but there is more than one reason to charge a lot for a product, one is the material used (which I don't expect to change much), but there are many others, such as creativity of design, utility, etc.

When you look at Shapeway's store you can see so much intricacy in some products. With a $10 block of plastic I can make a product that would otherwise sell for $100, now sell for $10.

Re:Shapeways (3D Printing Startup) Raises $5MM Series A from... by steveklabnik on Thursday September 23, 2010 @01:31PM (#1720465)
Trust me, I'm totally on your side. Theres a reason this tech has been around since the 80s, but things like the MakerBot has only happened recently, that's all I'm saying.
Re:Shapeways (3D Printing Startup) Raises $5MM Series A from... by ghjklkjh on Thursday September 23, 2010 @02:44PM (#1720770)
The reason is that the software was always very difficult (and expensive)

People that had, and could drive, Solidworks weren't interested in making one-off bits of jewelry and the artists that were couldn't drive the CAD system.