News for hackers. Stuff that matters.

A comment on 3-D printed plastic objects that can communicate with WiFi devices.

Re:3-D printed plastic objects that can communicate with WiF... by bpowah on Wednesday December 06, 2017 @10:35AM (#15861833)
So my WiFi should easily be able to detect if my (all metal) garage door is open or closed? I would like this. I run dd-wrt. Is there an all-software solution to this? Or does this research rely on fairly specialized hardware? (sorry, didn't have time to read the whole article)
[ Parent | on HN ]
Re:3-D printed plastic objects that can communicate with WiF... by siegecraft on Wednesday December 06, 2017 @11:48AM (#15862553)
Probably, the first thing I thought about when I saw this was WiSee ("Whole-home gesture recognition using wireless signals"), which is also from UW: http://wisee.cs.washington.edu/
[ Parent | on HN ]
Re:3-D printed plastic objects that can communicate with WiF... by regularfry on Wednesday December 06, 2017 @12:22PM (#15862882)
The research relies on special hardware, but you don't. I wouldn't be surprised if you could tell whether your door was open or not just from signal strengths of external wifi signals.

On reading the paper rather than the article: it's even simpler than I thought. No custom hardware necessary.

[ Parent | on HN ]
Re:3-D printed plastic objects that can communicate with WiF... by icebraining on Wednesday December 06, 2017 @11:11AM (#15862179)
It requires a custom 3D-printed "device" on the door, which would modulate the Wi-Fi waves being scattered around (by your router, laptop, etc) into a signal that would indicate "open" or "closed".
[ Parent | on HN ]
Re:3-D printed plastic objects that can communicate with WiF... by helb on Wednesday December 06, 2017 @12:48PM (#15863139)
I think the point was that the large moving metal object (garage door) itself would mess with the signal enough to detect the state without any additional device…
[ Parent | on HN ]
Re:3-D printed plastic objects that can communicate with WiF... by detaro on Wednesday December 06, 2017 @01:42PM (#15863677)
I guess a first good experimental step would be to point a directional Wifi antenna in the direction of the door and monitor what it receives at what strength.
[ Parent | on HN ]
Re:3-D printed plastic objects that can communicate with WiF... by TeMPOraL on Wednesday December 06, 2017 @01:27PM (#15863539)
Yup. And the actual implementation difficulty is in setting up the detection/analysis stack.
[ Parent | on HN ]
Re:3-D printed plastic objects that can communicate with WiF... by adrianN on Wednesday December 06, 2017 @11:44AM (#15862512)
You could probably adapt this technique https://www.youtube.com/watch?v=aqqEYz38ens to detect your garage door state.
[ Parent | on HN ]