If that's their per-sample time, they probably would've dissolved by now after admitting total defeat - 20 Hz is totally unusable for navigation. I'd guess that that's something more like maximum latency from real world to computer, either due to deep pipelining or because they communicate data frames rather than a stream of individual samples. Very easy for that kind of thing to fall through when talking to the media.
https://www.strobeinc.com/strobe-lidar/
> Number of pixels and field of view is controllable in real time to 'zoom' the resolution.
and the IEEE quote is a bit ambiguous (emphasis mine):
> An image on Strobe’s website seems to suggest that the lidar will be much smaller too, with a footprint as small as an American quarter. A number of these would be needed to generate the 360-degree coverage provided by the rotating, roof-mounted lidars seen on many experimental self-driving cars today.
Needing several implies a fixed field of view, but that could be either 1D or 2D. Given the size of the device (a US quarter apparently) it could be an area imaging device, but that would imply a pretty big improvement in optical technology to get enough signal-to-noise per pixel. I know they claim FMCW requires less sensitive detectors, but there's a limit.
If it was only 1D, it would be utterly unfit for navigation if you just scatter a few of them around on the vehicle in fixed locations like their marketing suggests. You can't replace a spinning roof-mounted lidar with just a few fixed 1D sensors. The spinning lidar gets something on the order of one sample per degree, right? To even come close to replacing that with fixed 1D sensors you'd need on the order of 360 of them around the vehicle, and their marketing doesn't sound like that they expect you to use anywhere near that many.
What? I've seen lots of autonomous robots that operate at 10 Hz, including mission critical systems for the military. Compared to cameras, which might operate as fast as 60 Hz (but are far more likely to operate at 30 Hz or a fraction thereof) I am confused where you're getting these numbers from. Do you have any citations?
Notable that this is an FMCW system. Very few commercial players use frequency modulation, they all use either AM or pulsed lasers.
Rep rate is not so good. 45 ms = 20Hz maximum. That's poor compared to Velodyne (15kHz or so per transceiver) or surveying stations which can push 1MHz. Even hobbyist systems like the Scanse manage 4kHz. I'd guess that the problem is, in part, because you need to chirp for a certain amount of time. Pulsed systems often use avalanche diodes that trigger from relatively few photons.
It's 1D, so you've still got to scan it which is bad for robustness. I'm more excited for solid state LIDAR that uses beam shaping (or however they're doing it) to scan without moving parts.
The range is good though, FMCW is great for that (and the accuracy should be good too). The main advantage of FMCW is that you can still get the high accuracy of AMCW systems (i.e. at a lower bandwith than direct time of flight), but you don't have the phase ambiguity problem that AM does.