News for hackers. Stuff that matters.
Re:Can you figure out how this single part boost converter w... by Animats on Friday June 09, 2017 @02:12AM (#14519482)
See the data sheet for the part.[1] Basically, you want to feed power into the inductor briefly, then turn off power and somehow connect the inductor to the LED. The trick is to find some way to get the microcontroller to connect two of its own pins together, so you can use it as a switch on the output. This is probably done by abusing one of the alternate uses of the six "B" pins. See table 10-3. I'm thinking that port B, bit 5, DW mode might be abusable in this way.

[1] http://www.atmel.com/images/atmel-2586-avr-8-bit-microcontro...

Re:Can you figure out how this single part boost converter w... by qb45 on Friday June 09, 2017 @04:27AM (#14520003)
This exact solution is described at the end of the post except that they call it RESET pin rather than DW pin. And of course they short it directly to GND by driving low, you can't just short two GPIOs together.