News for hackers. Stuff that matters.
Re:Iceland drills 4.7 km down into volcano to tap clean energy by GregBuchholz on Friday May 05, 2017 @02:46PM (#14275845)
>Well costs are ~quadratic in depth.

Anyone know as to why this is the case? At first pass it seems like your cutting tools should wear out in proportion to depth. But I suppose as things get warmer tool wear becomes faster. What types of tool materials are used for rock boring? Diamond? Tungsten carbide? Is is more of a "conventional machining" process, or an abrasive / water jet? Or explosive like in hard rock mining? What else has an effect on cost for deep holes? Shaft length gets longer, so the twist becomes more of a problem if your are driving rotating bits from the top? Does it have to do with removing the material from the bottom of the hole to the top? Others?

Re:Iceland drills 4.7 km down into volcano to tap clean energy by cnnsucks on Friday May 05, 2017 @04:30PM (#14276616)
"Anyone know as to why this is the case?"

Think of a telescopic antenna. That structure is similar to what is done to bore a well. You start with large casing diameter and add progressively smaller casings until you reach the target depth. The deeper you go the bigger the casing you must start with. Offshore deep water stuff can be a meter in diameter with 10cm solid steel walls; monstrously heavy and costly materials. And you use kilometers of the stuff.

There are a lot of reasons why costs scale as they do with depth; casing is just one of the more obvious.

Re:Iceland drills 4.7 km down into volcano to tap clean energy by GregBuchholz on Friday May 05, 2017 @04:59PM (#14276807)
Anyone recommend a good pop-sci book on deep hole boring? Seems like it could be an interesting light engineering read.
Re:Iceland drills 4.7 km down into volcano to tap clean energy by lumost on Friday May 05, 2017 @05:34PM (#14276993)
For deep wells would the need for casing change depending on the material you're drilling into? once your into hard granite bedrock I'd imagine wells of a certain diameter are stable with minimal to no casing.
Re:Iceland drills 4.7 km down into volcano to tap clean energy by cnnsucks on Friday May 05, 2017 @08:29PM (#14277902)
Yes, geology is a big factor in engineering a well. Pressure is another. Every well is engineered to the prevailing conditions and requirements. Sometimes it is possible to elide heavy casing which can save large amounts of money.