Why add a bunch of unnecessary complexity? It's just more stuff to break (not to mention more up front cost).
1. By adding an additional lower gear to an electric truck/4x4, it could provide even more torque at low gears to allow it to carry more load and go up steeper inclines.
2. By adding an additional higher gear to a car, it could go faster and accelerate faster at the top RPM end(s). For example, see how the acceleration drops quickly. That wouldn't happen if you were to keep switching to higher gears:
http://static4.consumerreportscdn.org/content/dam/cro/news_a...
The reason they didn't do this in the Tesla was a technical problem, but that could be remedied:
https://forums.tesla.com/forum/forums/adding-second-gear-spe...
"The roadster originally was developed using a two speed gear box. However, they had problems getting it to handle the massive instantaneous torque that the motor could produce, so they went for a single speed."
Note: while I think this is probably true for electric vehicles that don't offer this option, this is inaccurate for gas vehicles. Manual transmission cars are still cheaper currently and are sold by major manufacturers. Major manufacturers will typically pass on additional cost to the consumer.
The comparison is not between an automatic and a manual transmission. It is between _any_ transmission and "no" transmission.
Yes, a manual transmission is cheaper than an automatic, but both are more expensive than "no" transmission[1], which is why electric car manufacturers aren't bothering with them for mass-market vehicles.
[1] Obviously there is still gearing transmitting power to the wheels from the motor, but in the case of electric cars, it can be a single fixed-ratio set of gears, rather than multiple sets of gears and one or more clutches...
With an automatic, the "meaning" of the gas pedal will vary wildly depending on previous state. On a manual you can feel/see the setting, and more importantly, you can set it and thus anticipate exactly when it changes meaning.
http://www.autoguide.com/auto-news/2015/02/why-lamborghini-t...
For a more in-depth analysis of this, see:
https://www.quora.com/Why-is-the-market-for-manual-transmiss...
However, there are still many that prefer manual, despite things potentially wearing out more quickly. And- you don't have to design a clutch that allows the driver to wear out things more quickly. You could still allow the driver to select the level of torque but only adjust for that in a way that would not cause damage.