News for hackers. Stuff that matters.
Re:What does a kilowatt hour look like? by userbinator on Thursday September 22, 2016 @10:31PM (#12561927)
I think your concerns are somewhat alarmist and tend to be a bit scaremongering. You may want to read an actual study about just how much HF is present in the fumes of burning cells. In this one, near the end they burned a whole laptop pack and analysed the gases that were emitted:

http://www.brandforsk.se/MediaBinaryLoader.axd?MediaArchive_...

The relevant datapoint is on page 61:

"As seen the yields of HF is much lower for the lap top cells, in fact the HF detected online was below the determined detection limit."

The graphs on page 101 also show HF concentrations below 4ppm --- and keep in mind this is basically all of the gases collected from the burning pack. Looking at the safety data for HF, the permissible exposure limit is only slightly lower at 3ppm and it's immediately dangerous at 30ppm.

In other words, it would be a bad idea to deliberately concentrate and inhale the fumes of a burning cell, but the HF probably isn't going to kill you. Some good ventilation of the area should be sufficient.

Re:What does a kilowatt hour look like? by spdustin on Friday September 23, 2016 @01:49AM (#12562589)
I had to come back because the paper doesn't specify the chemistry of the laptop battery; you can't use this as evidence to support anything other than caution around Li-ion batteries and cells.

And, more alarmingly, the part you omitted or glossed over: their plausible explanation for the lower HF detection (which, again, would depend wholly on the chemistry of the cells):

> the laptop cells exploded with liquid splashed on the walls in the equipment

Whoops.

Don't mess with these things unless you know how they can be safely tested, safely charged, and safely monitored. Li-ion protection failures (of various modes) were responsible for the Boeing Dreamliner fleet being grounded, Tesla refitting their battery packs (road debris caused a fire when it pierced a Li-ion cell), hoverboards being recalled, millions of dell laptops recalled after battery fires, and more recently, the Samsung Galaxy Note 7.

So, yeah. Safely tested, charged and operated is the key, and I wouldn't want to take that responsibility for a pack with as many batteries (and who knows which ones have their own standalone protection circuit in the cap) as in TFA.

Re:What does a kilowatt hour look like? by userbinator on Friday September 23, 2016 @06:30AM (#12563532)
And, more alarmingly, the part you omitted or glossed over: their plausible explanation for the lower HF detection (which, again, would depend wholly on the chemistry of the cells):

> the laptop cells exploded with liquid splashed on the walls in the equipment

The less electrolyte that gets burnt, the less HF generated, which I hope you agree is a good thing.

and more recently, the Samsung Galaxy Note 7.

How many actually burned? It's a very tiny fraction. Manufacturers recall precisely to avoid the sort of hysteria that statements like yours generate, and it's not any indication of impending doom. The aviation industry is particularly risk-averse, so it's not surprising. But I don't think the risk is very high compared to a lot of other things in our lives, especially when you consider all the lion cells out there of questionable quality in use and yet behaving themselves. China has taken the lead in making 18650s and other lion cells almost as easily available as alkalines, but reports of fires do not appear to have increased anywhere near in a direct proportion to that. (Reports of cells failing to meet capacity specs, on the other hand...)

By all means handle with care (as you should with any energy source), but lion cells are not lethal weapons that will instantly kill you at the slightest provocation.

Re:What does a kilowatt hour look like? by spdustin on Friday September 23, 2016 @09:22AM (#12564354)
Are you serious, or trolling? Weird question to ask outright, but I wanted to save time.

Regarding the battery exploding. Yeah, I'd agree that ... no! No, I don't agree at all! First, it exploded, so there's that. A cell in the middle of a multi-cell pack has nowhere to go. Second, it invalidated the experiment; they don't know how much HF would've been released in a real world scenario where the compressed cylinder of reactive metals and gasses is not free to "rapidly disassemble" into the air.

Now, moving on to Samsung's recall. How many failed? Sure, a small fraction. Do you know if yours will fail? How could you possibly know? Wait, I had something for this... oh, yeah. Safely test each cell.

Samsung didn't have that capability, their battery vendor didn't have enough engineers for all those house calls. You don't have that capability (you seem quite cavalier about the whole endeavor, so I'm guessing there). So, yes, since they can't know without testing, they recalled them all. What do you suppose they'll do then?

Probably, get together with the vendor, and test them.

Please stop suggesting to other readers that these things are perfectly safe when you know they're not. They're not tiny little bombs waiting to go off if you sneeze near one, but anyone using untested lithium-ion cells/batteries in untested configurations without a controller on each cell should be discouraged. We don't need a new category of Darwin award winners.

Re:What does a kilowatt hour look like? by spdustin on Thursday September 22, 2016 @11:46PM (#12562175)
The PF6 ions in the electrolyte of some Li-ion batteries (not all use the same chemistry) will readily combine with hydrogen in the air to form HF if the battery is combusting. Cylindrical Li-ion cells, like those part of an 18650 battery, literally hold their chemistry under pressure, and a thermal runaway will normally cause the vents in the cell to release the pressure.

If that's happening due to a short (which can and does happen when a cell is charged improperly, or even put under resistive load after the cell is discharged below a safe limit -- copper or other ions, depending again on battery chemistry, can literally bridge across the electrolyte to short the cathode and anode) the result of the release of pressure combined with the reactive nature of now exposed lithium is a small rocket that shoots a plume of gasses like sulfur dioxide or hydrofluoric acid. Again, this depends largely on battery chemistry, and without an MSDS on these particular cells, there's no way to know. But there's a reason why any chemist you care to phone up will say, if you tell them you're in possession of a cylinder of a compressed compound that contains fluorine (it won't matter what kind, fluorine really really likes to bond promiscuously and with reckless abandon), they'll tell you that you're braver they are. Tell them you're intend to string up a few hundred of them and pass an electric current into them, and they'll call a hazmat team for you.

A casual stroll through forums frequented by flashlight fans (yeah, it's a thing) and you'll see plenty of demonstrations of what happens when a Li-ion cell begins a thermal runaway. And plenty of memorials to those who gave up their passion because they're on ventilators after experiencing profound damage to their lung tissues. Hell, ask the firefighters that respond to a fire at a battery recycling plant; granted, that's a bigger scale than one cell, but even one cell in a small room can, depending on its chemistry and how violently it's outgassing, emit enough HF to cause lung damage.

Read an MSDS yourself: http://www.uscg.mil/hq/cg4/cg432/docs/msds/MSDS_LiIon.pdf

LiPo "pouches" mentioned elsewhere in this thread are much less likely to explode spectacularly before bursting, and much less likely to exhaust a plume of corrosive, toxic chemicals in their wake.

Re:What does a kilowatt hour look like? by rsync on Friday September 23, 2016 @08:51AM (#12564152)
"A casual stroll through forums frequented by flashlight fans (yeah, it's a thing) and you'll see plenty of demonstrations of what happens when a Li-ion cell begins a thermal runaway. And plenty of memorials to those who gave up their passion because they're on ventilators after experiencing profound damage to their lung tissues."

I was interested to read about flashlight enthusiasts on ventilators, but all I could come up with was this:

http://www.candlepowerforums.com/vb/showthread.php?141137-In...!

Re:What does a kilowatt hour look like? by userbinator on Friday September 23, 2016 @07:01AM (#12563639)
Cylindrical Li-ion cells, like those part of an 18650 battery, literally hold their chemistry under pressure, and a thermal runaway will normally cause the vents in the cell to release the pressure.

Unlike what you seem to be implying, lion cells are NOT "under pressure" in normal use. They are at atmospheric pressure. The vent is specifically so in case of abnormal conditions, it allows any pressure to escape instead of causing the cell to explode.

result of the release of pressure combined with the reactive nature of now exposed lithium

In a lion cell, there is no "exposed lithium" in the metallic, highly-reactive sense. It's a solution of lithium ions in an electrolyte, whose only real hazard is its flammability.

I believe I know the flashlight forums you refer to, and the incidents of HF poisoning too. Those were lithium primary cells, which actually contain significant quantities of metallic lithium and are definitely more reactive than lion. Even the MSDS you refer to says "in spite of their name, these batteries do not contain any lithium metal".

The MSDS is also the easiest way to scare yourself into thinking everything is highly dangerous. For example, look at the ones for sodium chloride. By the way, I would not trust that one so much as it gives a boiling point for ethyl acetate, a liquid at room temperature, of -84C. Similarly, dimethyl carbonate is listed as boiling at +4C, when that's its melting point. Perhaps that's where your impression that the cells are normally under pressure came from?

Likewise, I recommend looking at the data on the electrolyte solvents:

https://en.wikipedia.org/wiki/Ethyl_acetate

https://en.wikipedia.org/wiki/Diethyl_carbonate

https://en.wikipedia.org/wiki/Dimethyl_carbonate

Not totally harmless, but not insanely toxic either.