News for hackers. Stuff that matters.

cmpx

Great idea! Actually the mk3 of the PCB had these parts on the bottom. The reason for putting them on the top layer was that this way we can decrease the thickness of the macropad (we don't need much space between the pcb and the backplate). For now it is basically a tradeoff. One way of improvement could be, that we don't use a BLE module, but solder the MCU directly to the PCB and use smaller passive components. This way the max. height of the components could be decreased and we could put them back on the bottom. This would also mean I have to design the RF parts, which is very far outside of my knowledge.
Thanks!

About the buttons in the corners, I wish we could use that space too! :) Most of the electronic components (MCU, power supply circuit) are located in the corners, while the remaining PCB area is occupied by the mechanical switches, display/battery, and the encoder.

Thanks!

We planned to use ESP, but turned out it needs a lot of energy, so we are using nrf52840 MCU. Yes, we are using lvgl! Such a nice library!

Show HN: Creavi Macropad – Built a wireless macropad with a display

https://creavi.tech/blog/creavi-macropad-build-log/

Hey HN,We built a wireless, low-profile macropad with a display called the Creavi Macropad. It lasts at least 1 month on a single charge. We also put together a browser-based tool that lets you update macros in real time and even push OTA updates over BLE. Since we're software engineers by day, we had to figure out the hardware, mechanics, and industrial design as we went (and somehow make...

( Read More... | 7 comments | 17 points | on HN )