That said, most of the drives in this article are consumer drives. The problem with consumer drives is that they don't have capacitors. And since your writes are cached by the drive before they go to the NAND, if you lose power all of your drives will be corrupted in the exact same way at the exact same time.
If you don't care about the data, go ahead and use them. If you do pay the extra for Enterprise drives. They really aren't _that_ much more expensive these days.
I'm genuinely interested.
We have only had two Intel drives die on us. I'm interested (well academically, not professionally) if they will die at the same time or keep dropping off one at a time.
We tend to retire the machines or the drives in them before they fail.
In general, thermals tend to be a significant issue for all form factors when devices are retrofitted. Less so for 'products' (All flash arrays etc.) which are designed as whole products from the outset.
This creates a failure pattern that is totally separate from predictable wear due to use and means that 'they'll all die at the same time' becomes much less certain for some categories of device.
Also, there's the controllers, which tend to be a significant source for issues.
So yeah, maybe theoretically, the wear out would be a concern for raid. However, practically this is rarely an issue as other failures randomize the distribution enough to where this never causes a problem in-situ.
SSDs have a fairly consistent failure curve (exusing firmware bugs and other random events) for a given model, so they'll wear evenly in a raid setup. This means they'll all die at the same time as writes/reads are distributed fairly evenly across the disks. Given the size of today's drives, you may not complete a rebuild before losing another disk.
Has this been proven to not be true within the past few years? I don't run redundant raid on ssds. It's either raid0 or jbod.