News for hackers. Stuff that matters.
Re:A400M Airbus Flier crashed because of software issues by sokoloff on Tuesday May 19, 2015 @01:34PM (#9571730)
Your post is substantially correct, with a clarification on rotation speed(Vr) vs takeoff decision speed (V1).

There are three relevant speeds for large aircraft. (I'm going to generalize very slightly to keep this short and readable.)

V1, Vr, V2.

V1 is the takeoff decision speed. An engine failure recognized before reaching V1 is handled by aborting the takeoff. An engine failure recognized after reaching V1 is handled by continuing the takeoff. At the V1 callout, the pilot flying removes their hands from the top of the throttles (as a physical reminder that aborting/rejecting the takeoff(RTO) is not happening for a simple engine failure).

Vr is the rotation speed, where the nose wheel is lifted from the ground.

V2 is the speed at which the airplane will climb safely with one engine INOP.

In most cases, V1 is the lowest speed, meaning there are cases (between V1 and Vr) where an engine out with the nosewheel on the ground results in continued acceleration, then rotation, and flight.

It's a checkride bust to RTO above V1 for a simple engine failure.

Re:A400M Airbus Flier crashed because of software issues by inetsee on Tuesday May 19, 2015 @06:21PM (#9573548)
Thank you for clarifying my post. I am not a pilot. I am a software engineer (retired). I worked briefly on the C-130J mission computer operating system, then on the maintenance software the ground crews used to maintain the aircraft.

I did not know that there was a situation when a flight crew would continue a take off after an engine failure but before rotation.