How AeroPress Fans Are Hacking Their Way to a Better Cup of Coffee

Re:How AeroPress Fans Are Hacking Their Way to a Better Cup ... by tholmes on Wednesday April 15, 2015 @05:10PM (#9384156)

The inverted method essentially involves waiting for 45-90 seconds and then pressing. It's not going to leak or anything when you flip it unless you go absolutely wild. It's no harder than making a non-inverted aeropress or a pourover.

Or if you accidentally put the plunger in the wrong side and don't notice before you fill it up. I did that once :)

[ Parent | on HN ]

Re:How AeroPress Fans Are Hacking Their Way to a Better Cup ... by saidajigumi on Wednesday April 15, 2015 @05:21PM (#9384241)

> It's not going to leak or anything when you flip it unless you go absolutely wild.

Motion seconded. I used to think inverted seemed complicated as well, but once you've done it, it's pretty darn straightforward.

[ Parent | on HN ]

Re:How AeroPress Fans Are Hacking Their Way to a Better Cup ... by wampus on Wednesday April 15, 2015 @05:23PM (#9384264)

The nicest thing about the inverted method is the consistency of results, because nothing's leaking out during steeping.

Still, I hesitate to recommend it to some people, not because it's difficult, but because I know they might use boiling hot water straight from the kettle and risk injury. Under the right conditions, it can separate when screwing on the filter cap, due to the steam pressure.

[ Parent | on HN ]

Re:How AeroPress Fans Are Hacking Their Way to a Better Cup ... by joezydeco on Wednesday April 15, 2015 @05:39PM (#9384355)

Knocking over the cylinder while steeping is also a hazard. I've done it once or twice while working too fast around the counter and it's....messy.

[ Parent | on HN ]