News for hackers. Stuff that matters.
Re:How a bad RJ45 termination can ruin a cable by _kerbal_ on Saturday March 28, 2015 @10:56PM (#9283702)
Correctly crimping RJ45 is one of those things that seems impossible, but once you get the hang of it works out most of the time.

- Make sure your wires are extending far enough into the plug, you should see the wire fully overlap the brass spades.

- Confirm you have the right wire layout by looking through the plug before you crimp the cable.

- As mentioned in the article, the tail part of the connector is meant to cover the tip of the cable's insulation to provide a bit of stress relief, make sure it's not too short.

There are no comments on this comment yet.