News for hackers. Stuff that matters.
Re:Why it takes so long to get data back from New Horizons by raverbashing on Tuesday February 03, 2015 @10:12AM (#8990733)
Funny how it's as slow as the first modems

Of course, the channel adds a lot of noise and attenuation

(I'm not sure the rate they mention is the effective ratio or before Error Correction Codes)

Re:Why it takes so long to get data back from New Horizons by throwaway_yy2Di on Tuesday February 03, 2015 @11:37AM (#8991319)
This paper says the downlink uses a rate 1/6 forward ECC -- 6 encoded bits for every 1 message bit. From the context, the ~1 kbps figure should mean the information rate; the tone rate would be 6x higher.

    6.3. DOWNLINK SYSTEM PERFORMANCE
    
    The downlink card in each IEM is the exciter for the TWTAs
    and encodes frame data from the spacecraft C&DH system into
    rate 1/6, CCSDS turbocoded blocks.
http://www.boulder.swri.edu/pkb/ssr/ssr-fountain.pdf

and more details,

http://www.boulder.swri.edu/~tcase/NH%20RF%20Telecom%20Sys%2...

Re:Why it takes so long to get data back from New Horizons by kabdib on Tuesday February 03, 2015 @11:01AM (#8991054)
110 or 300 baud were the "first" modems. My first 1200 baud modem just screamed. In comparison, of course.

An effective 2000 bits/second from Pluto is the stuff of science fiction. (Actually, even SF from the 50s was full of situations like being out of radio contact with Earth because of distances on the order of an AU or so. With available technology they were probably right).

Re:Why it takes so long to get data back from New Horizons by mchouza on Tuesday February 03, 2015 @12:11PM (#8991570)
It's mostly a question of power. The 1987 design for the TAU probe communication system would have handled 20 kb/s from 1000 AU... by using between 100 and 260 watts for the transmitter (and relatively big antennas):

http://ipnpr.jpl.nasa.gov/progress_report/42-89/89L.PDF