News for hackers. Stuff that matters.
Re:Drone carrying drugs crashes near US-Mexico border by pavel_lishin on Thursday January 22, 2015 @02:16PM (#8931081)
I'd imagine that 3D printing is already good enough to print most of a drone; the only things you'd need to order would be wires, a control board (arduino?) and motors.
Re:Drone carrying drugs crashes near US-Mexico border by miahi on Thursday January 22, 2015 @02:59PM (#8931368)
You usually need something strong for the frame; big drones are carbon fiber - and I don't think you can print anything like it right now.

Other things on the parts list are the motor controllers (motors are controlled by current, and you usually need at least 40Amps for each), battery and sensor board (GPS, compass, 3D acceleration and gyro).

Re:Drone carrying drugs crashes near US-Mexico border by baddox on Thursday January 22, 2015 @05:00PM (#8932043)
There's no need for carbon fiber, and besides, you can buy carbon fiber beams and poles that are used for much more than just RC aircraft. Any multirotor frame you can build with carbon fiber you could build with fiberglass, aluminum, or even wood and plastic without significant performance reduction that would be relevant to hauling drugs short distances.