Re:Micro heaters cut 87% off my electric heat bill
by mikeash on Thursday July 31, 2014 @11:25AM
(#8114639)
Virtually all thermostat-controlled heating systems I've seen don't have different output levels, but are just on or off. So poor efficiency at high output wouldn't come into play.
The rest is possible, but I'd file using expensive electricity instead of cheap electricity under the thermostat not doing a very good job, or more precisely the person setting it up not doing a good job of setting it up to run more cheaply.
Re:Micro heaters cut 87% off my electric heat bill
by pbhjpbhj on Thursday July 31, 2014 @11:52AM
(#8114820)
Gas fired combi boilers (with centrally heated [pumped] cycling water) are pretty much the default in the UK. I've never seen one that didn't have output temp adjustments. I'd imagine that set highest (which should reach thermostat set target temp fastest) would produce greatest flue losses but I'm speculating there.
Re:Micro heaters cut 87% off my electric heat bill
by mikeash on Thursday July 31, 2014 @12:24PM
(#8115023)
I meant controlled by the thermostat. I'm sure you can adjust it manually, but in normal operation, it's cycling between on and off, and nothing more. Output level when heating your house from 50F to 70F is the same as heating your house from 69F to 70F, it just runs longer.
I'm sure there are exceptions to this somewhere, but it doesn't seem common. Thermostats don't typically have a way to command anything besides on and off.
If you're heating with electric for example you can sometimes buy electricity far cheaper at night (demand is low and traditional production can be easily spun-down). Thus buying electricity all night and keeping the house warm, whilst using more electricity, could be cheaper than paying for peak rate electric.
Physics alone could explain it in very rare circumstances - board construction that expands in warm air closing gaps, cool air opens gaps and causes more cooling. Heat exchange rate from in- to outside is then possibly greater at lower temperatures. Houses aren't simple to model.