News for hackers. Stuff that matters.
Re:Introducing Raspberry Pi B+ by kenrikm on Monday July 14, 2014 @02:30AM (#8029718)
I hope the USB ports will now output enough voltage to actually power common peripherals without using a hub.
Re:Introducing Raspberry Pi B+ by mrmagooey on Monday July 14, 2014 @02:36AM (#8029728)
Given that it's a USB plug powering the device, I doubt it, although maybe the lower power usage by the Pi might provide some extra overhead.
Re:Introducing Raspberry Pi B+ by ShaneCurran on Monday July 14, 2014 @09:38AM (#8030818)
It's nothing to do with the voltage, USB is always 5v. It's about the current these ports can draw, which is 1.2A for the 4 (i.e. 0.3A each if all 4 are under load)
Re:Introducing Raspberry Pi B+ by yzzxy on Monday July 14, 2014 @02:50AM (#8029754)
The question IIRC is if the new model will request high amperage from USB ports that can provide it, allowing more peripherals.
Re:Introducing Raspberry Pi B+ by ekianjo on Monday July 14, 2014 @02:37AM (#8029730)
Not sure if this is the case since they announced "reduced power consumption" ?
Re:Introducing Raspberry Pi B+ by ibrahima on Monday July 14, 2014 @02:46AM (#8029747)
When they say reduced power consumption, they're really talking about overhead. Let's say to supply 5W at 5V, they needed to take in 7W at 120V. This means that voltage step down process results in some power being wasted as heat. By using a switching regulator they waste less power and thus there's less heat output, but the power delivered to the device remains the same. So, in this example, they might only need to take in 6W at 120V to output 5W at 5V. (Note, the numbers are complete BS because I haven't done hardware in a while, but that should give you an idea.)
Re:Introducing Raspberry Pi B+ by pjc50 on Monday July 14, 2014 @09:17AM (#8030730)
The numbers are referring to the wrong voltages entirely. It takes in 5V and down-converts that to 3.3V, 2.5V and 1.8V.

https://learn.adafruit.com/introducing-the-raspberry-pi-mode...