News for hackers. Stuff that matters.
Re:Google offering $1M prize for a much smaller power inverter by krushin on Sunday May 11, 2014 @06:02PM (#7730198)
I know this would be worth quite alot...

but given google is sponsoring this. What kind of application could this have, or better yet if we get one that is super small/meets the qualification. What kind of potential does it have?

Re:Google offering $1M prize for a much smaller power inverter by drakaal on Sunday May 11, 2014 @06:05PM (#7730205)
Power has to be stored as DC.

If google wants to "own the grid" and we know they do. Then power will need to be efficiently converted from DC to AC.

If you do this at the outlet, then LED's and other DC favoring electronics could be powered by wires that are DC, and AC would only be used when necessary.

Think of all the devices you have with a power brick to take AC to DC. All of those are losing electrons along the way... (most power supplies are less than 75% efficient).

Re:Google offering $1M prize for a much smaller power inverter by dannypgh on Sunday May 11, 2014 @06:42PM (#7730321)
Power does not need to be stored as DC. Flywheels store rotational energy, and starting with a spinning flywheel it's pretty simple to get AC out of it.
Re:Google offering $1M prize for a much smaller power inverter by eigenvector on Sunday May 11, 2014 @07:09PM (#7730409)
True, but your electrical output would be variable-frequency AC at the drive terminal. This isn't particularly useful unless you use a back-to-back converter (i.e. DC link) to get constant-frequency AC.
Re:Google offering $1M prize for a much smaller power inverter by derekp7 on Sunday May 11, 2014 @07:44PM (#7730499)
Would it have to be variable? If it goes through a CVT, then you can keep the output whatever speed you want.
Re:Google offering $1M prize for a much smaller power inverter by eigenvector on Sunday May 11, 2014 @08:06PM (#7730544)
I'm no mechanical engineer but at first glance the conversion efficiency of using a CVT with a synchronous AC drive (vs. direct coupling the motor rotor and the flywheel rotor and using a variable-frequency induction motor + back-to-back converter) would seem to be lower.

Modern VFDs have very high part-load efficiency and we can easily maintain a constant power characteristic through the full speed range by operating in the field weakening mode. One way or another you're losing energy in frequency conversion, it's just a question of whether you do that mechanically (with CVT) or electrically (with back-to-back converters).

Also keep in mind that for grid storage devices, we're usually talking about 500+ kW on each flywheel which, at low speed, is A LOT of torque.

Re:Google offering $1M prize for a much smaller power inverter by drakaal on Sunday May 11, 2014 @11:16PM (#7731046)
That would not be efficient. Yes you could also store the energy by pumping water up hill and letter it turn a turbine later, but you'd lose a LOT of power.

You could store the energy in springs ala the da Vinci cart, but again not efficient.

All of these methods require a conversion, where as a Battery, Capacitor, or Leyden Jar will store DC as DC.

Re:Google offering $1M prize for a much smaller power inverter by dannypgh on Monday May 12, 2014 @03:02PM (#7734748)
Converting electric power to and from a battery requires an electrochemical reaction to occur. That is a conversion just the same - I don't really buy this "no conversion required" argument, just because you started and ended with direct current.

Flywheels aren't some hypothetical means of storing power, either - they've seen a lot of exciting R&D over the last 15 years, and there are operators of grid-scale flywheels. e.g. http://beaconpower.com/ http://en.wikipedia.org/wiki/Flywheel_energy_storage

Re:Google offering $1M prize for a much smaller power inverter by nsrango on Sunday May 11, 2014 @06:13PM (#7730234)
Additionally AC transmission is inefficient compared to DC transmission; the skin effect[1] really kills you

[1] http://en.wikipedia.org/wiki/Skin_effect

Re:Google offering $1M prize for a much smaller power inverter by abstrakraft on Sunday May 11, 2014 @06:21PM (#7730258)
The efficiency gained by stepping up AC to higher voltage (and correspondingly lower current) is far greater than that lost to skin effect. Since there is no way to efficiently step up DC (modern DC-DC converters are still horribly lossy), AC transmission ends up being more efficient, by a long shot.
Re:Google offering $1M prize for a much smaller power inverter by eigenvector on Sunday May 11, 2014 @06:32PM (#7730286)
There are scenarios where HVDC can be more suitable than AC, in particular, very long distance links (e.g. to a remote hydraulic station). All of the substation equipment is much more expensive in HVDC but the benefit of eliminating line reactance can outweigh this if you're doing 1000+ km without any interconnections.

Also, interconnection between neighbouring AC grids is an important HVDC application since we don't have to worry about transient stability.

Neither AC or DC are superior. Different technologies for different applications.

Re:Google offering $1M prize for a much smaller power inverter by aaren on Monday May 12, 2014 @03:46AM (#7731570)
Can you explain like I'm a physics major why HVDC becomes more efficient than AC over ~1000km? A scale analysis would be great - where does the distance D come into the equation?

I get why AC is better than DC on ~100km, but I don't understand how it changes again at larger scales.

Re:Google offering $1M prize for a much smaller power inverter by eigenvector on Tuesday May 13, 2014 @01:45AM (#7736708)
It's a cost vs. energy carried trade-off.

Both systems have resistive loses proportional to the square of the current. However:

1. Total power transferred in a DC system is proportional to the voltage, whereas power transferred in an AC system is proportional to the RMS voltage (which is roughly 0.7 of nominal for a sine wave), so more energy is transmitted at the same current level in HVDC.

2. AC systems manifest impedance which has a resistive (aka DC) component as above as well as a reactive (aka AC) component, i.e. Z = R + jX. In DC systems X = 0. In a theoretical transmission line no energy is absorbed or supplied from line reactance, but in practice we have to transmit a certain amount of reactive power (VARs) to charge the line capacitance/inductance each AC cycle. This reduces the amount of our current capacity (limited by thermal constraints) that actually carries current that can be delivered to the load as active power (watts).

This effect is somewhat although not directly proportional to distance (characteristic impedance has no dependence on line length, but voltage drops along the line due to resistive effects meaning the variation from the optimal reactive power-minimizing voltage level increases).

The effect of (1) and (2) is that for any given conductor, at a given voltage level, more usable energy can be transmitted with DC than AC, and that differential increases with distance.

That being said, building DC converter and switching stations is much more expensive than AC. So for a shorter line, or one that has many switching stations, I could counter the above by simply generating 5-8% more power at the generating station and still come out ahead (because in real engineering everything is about $).

Therefore, DC is only more cost-effective ($/MVA of energy delivered) at long distances.

Re:Google offering $1M prize for a much smaller power inverter by aaren on Tuesday May 13, 2014 @06:50AM (#7737455)
Reactive power is the control then. With AC, we have to increase reactive power to shove more real power along the line, but reactive power doesn't transmit very well.

Follow on: in a national grid, could we just distribute the production of reactive power with capacitor banks in each town / neighbourhood? Heavy flywheels spinning at 50hz?

> building DC converter and switching stations is much more expensive than AC

Is this intrinsic to the technology or is it more because we have economies of scale from building infrastructure around AC for 100 years?

Thank you for this. Really helpful.

Re:Google offering $1M prize for a much smaller power inverter by onnoonno on Sunday May 11, 2014 @07:30PM (#7730469)
According to Wikipedia, this is not true anymore:

http://en.wikipedia.org/wiki/Hvdc

'Depending on voltage level and construction details, HVDC transmission losses are quoted as about 3.5% per 1,000 km, which is less than typical losses in an AC transmission system.[16]'

Re:Google offering $1M prize for a much smaller power inverter by dfox on Sunday May 11, 2014 @08:28PM (#7730615)
At line-frequency skin effect is not significant for almost any practical conductor (ie. reasonably conductive and with reasonable cross-section). What gets significant for long distance transmission is that few thousand kilometer long power transmission line starts behaving like, well, transmission line even on frequencies as low as 50/60Hz. Also HVDC elegantly sidesteps problem of grid synchronization.
Re:Google offering $1M prize for a much smaller power inverter by davepage on Sunday May 11, 2014 @08:48PM (#7730666)
Oh, that is completely not true for commercial AC power transmission -- just look up at a big power pylon and see the multiple power conductors per phase.

See the pretty blue picture: http://en.wikipedia.org/wiki/Skin_effect

Skin effect in copper is about 9mm at 60Hz

Re:Google offering $1M prize for a much smaller power inverter by dfox on Sunday May 11, 2014 @11:23PM (#7731064)
I assumed that skin depth at 50/60Hz is on the order of 20mm and that 40mm diameter conductor is not entirely practical to install on pylons (or generally in longer lengths than few meters), obviously I was slightly off in that estimate.
Re:Google offering $1M prize for a much smaller power inverter by coryrc on Sunday May 11, 2014 @11:09PM (#7731033)
That's part of the reason those power lines are steel-cored with copper jackets; the other reason being strength, of course.
Re:Google offering $1M prize for a much smaller power inverter by votingprawn on Monday May 12, 2014 @04:34AM (#7731682)
They're Aluminium over a steel core, not copper. A copper over steel version would be significantly heavier.
Re:Google offering $1M prize for a much smaller power inverter by coryrc on Saturday May 17, 2014 @04:09PM (#7760906)
headsmack yes, of course.
Re:Google offering $1M prize for a much smaller power inverter by eurleif on Sunday May 11, 2014 @06:13PM (#7730237)
Where is the DC ultimately coming from in this scenario? Is the whole grid high-voltage DC, or what?