News for hackers. Stuff that matters.
Re:The Hardware Revolution by learc83 on Monday March 10, 2014 @01:26PM (#7374304)
The biggest hurdle for most of the hardware I've been working on over the last few years, is the touchscreen.

It's very hard to get good quality (IPS panel, capacitive) 7-10" touchscreens in low quantities for reasonable prices (I know of 1 company who sells them for under $200, but they constantly run out of stock).

I've found it's cheaper to buy cheap android tablets for ~$100 and use them as thin clients, but then you have to deal with all of the restrictions google puts in place (mainly the lack of a kiosk mode).

You can create your own ROM to get past the restrictions, but 2 months later the tablet you were using is at end of life, and you're back at square one.

Someone could make a killing creating low cost android backed thin clients to use as interfaces for this "hardware revolution".

Re:The Hardware Revolution by iamwil on Monday March 10, 2014 @01:41PM (#7374413)
The direction many hardware startups have gone is to write networking code instead--if your customer demographic are people that are likely to have smartphones--, to have the interface on the phone instead of on the hardware device itself.
Re:The Hardware Revolution by sliverstorm on Monday March 10, 2014 @02:46PM (#7374872)
Yup, the smartphone-as-UI paradigm makes a lot of sense, as much as it irritates me sometimes.
Re:The Hardware Revolution by mng2 on Monday March 10, 2014 @04:53PM (#7375618)
Screens and cameras are two of the worst offenders for hobbyist/small-scale dev efforts. They're obviously everywhere, and obviously could be affordable, but either you can't find documentation for them without an NDA or they're way too expensive. Clearly somebody benefits from this secrecy.
Re:The Hardware Revolution by joezydeco on Monday March 10, 2014 @04:56PM (#7375641)
No, they benefit from the scale.

Any factory in China cranking out millions of 7" LCDs for the appliance and tablet markets isn't going to bother with support and service for a group that wants 100. That's why they're expensive and that's why you can't get datasheets for them.

If you're a serious customer and you can convince a local distributor of a manufacturer like Okaya, Sharp, or Ampire that you're serious (translation: you represent $$$), they'll give you all the stuff you want. Usually for free.

Re:The Hardware Revolution by mng2 on Monday March 10, 2014 @05:46PM (#7375895)
But that's exactly the problem I'm getting at: they make so many of these things, and while you can find them on eBay as replacement parts, there's no documentation on using them from scratch.

I don't even care about support. Does Atmel provide support to Arduino end-users? They just need to sell it to me with good enough instructions to make it work.