1.41 x
>Playing metal at full volume is not as damaging as playing anything intensely digitally clipped at full volume.
The output of the amplifier really ought to be bandwidth limited either as a natural consequence of the components used or explicitly with a filter. It is silly to spend power on things that can't be heard.
http://i.imgur.com/oE5NFZ9.png
(Just the left 1/2 of the graph for this example)
The integral of the sine waveform with a peak value of 1, on the interval 0 x < pi, is :
http://www.wolframalpha.com/input/?i=integrate%28sin%28x%29%...
= 2
The integral of the square wave on the same interval is = pi
So the ratio increase in average voltage at the speaker (comparing the sine to the square) is pi/2 = 1.57. The increase in speaker power is (pi/2)^2 = 2.46.
> 1.41 x
Yes, for a voltage of x, but remember that the speaker is a resistance, for which the power varies as x^2/r (Ohm's law: p = e^2/r), So the original claim is correct.
You shouldn't be able to blow up your speakers if your amp, speakers and limiters are setup correctly.
After all, if you're busting out £20k on a set of decent speakers, you don't want to burn them out because your idiot producer "turned it up to 11"
That's compression, not hard-limiting. Hard limiting would leave the quiet parts quiet relative to the loud parts. It would only crush them if they were not enough dynamics in the first place.
Maybe if your speakers are very quiet and crappy and you have to get every control to 100% (hardware, system, vlc) in order to hear anything - maybe in this case it will.
Hard clipping is very noticeable for the listener so not many people will set it to the maximum if they have choice.
Anyway, you can protect from this either in hardware or in the driver.
This is why distorting the amplifiers (especially digital clipping) is so much worse for speakers than overpowering the speakers. This is a very well known fact in audio circles.
Playing metal at full volume is not as damaging as playing anything intensely digitally clipped at full volume.
Yes, Dell is putting on shitty speakers on their laptops, (what else is new), but VLC should be amplifying the output using level-limiting (hard-limiting), which would effectively bring all the quiet parts to be just as loud as the loud parts, instead of just digitally clipping the output.