News for hackers. Stuff that matters.
Re:3D-printed Aerospike Rocket Engine by Geee on Wednesday January 29, 2014 @03:25AM (#7142690)
Hey nadirkazan. With 3D printing, could it be possible and affordable to make really tiny rocket engines for other uses, like radio controlled flying things? I'm thinking something like a moon lander, but smaller (really small, quadrocopter size). I would buy that :)
Re:3D-printed Aerospike Rocket Engine by avmich on Wednesday January 29, 2014 @02:29PM (#7146132)
The problem is not so much building as it is cooling small engines. Scaling works against you here. You can download a good simulating tool for liquid fuel rocket engines - http://www.propulsion-analysis.com/ - it will show how, when you're decreasing engine size and fuel flow it becomes not enough fuel to cool of the engine.

Spike nozzle is particularly problematic around the throat, which has bigger area than for a regular bell-shaped nozzle.

Re:3D-printed Aerospike Rocket Engine by Gravityloss on Wednesday January 29, 2014 @07:33PM (#7148243)
A heat sink engine could work in pulsed operation.
Re:3D-printed Aerospike Rocket Engine by avmich on Thursday January 30, 2014 @01:58AM (#7149390)
True. However this mode isn't very useful when you need to lift something from Earth - or just to keep it in the air.
Re:3D-printed Aerospike Rocket Engine by Gravityloss on Tuesday February 04, 2014 @11:13AM (#7178307)
You could have a glider. Or a boost-glide vehicle to be more precise.
Re:3D-printed Aerospike Rocket Engine by nadirkazan on Wednesday January 29, 2014 @02:53PM (#7146303)
Hi. Theoretically yes, and we started there, but as someone mentioned, it has really low efficiency and will work only for few seconds. It would be expensive, and people are likely to stick with solid rockets for heir simplicity.